Antenna Delete Plate
Antenna Delete Plate and optional amplified AM/FM antenna installation instructions:
Step 1. Unscrew the old antenna. Save the screws and the factory gasket as they will be reused.
Step 2. Take out the drivers side interior "A" pillar cover. Remove the door trim (kick panel). Also, peel back the floor carpet.
Step 3. Remove the radio and unhook the antenna from the back of the radio. Pull the cable back out the "A" pillar.
Step 4: Using the saved fasteners and gasket, install the block off plate on the A-pillar next. If you did not buy the optional antenna, reinstall A-pillar and kick panel and you’re done with the plate install. If you purchased the optional amplified AM/FM antenna go to step 5.
Loading...