GREISINGER GS 150 Operating Manual

S65.0.01.6C-02

GHM GROUP - Greisinger

GHM Mestechnik GmbH | Hans-Sachs-Str. 26 | 93128 Regenstauf | GERMANY



[phone] |  [phone] |  [e-mail]

Operating Manual

Gas sampling pump

GS 150



Please carefully read these instructions before
use!

WEEE-Reg.-Nr. DE 93889386



Please consider the safety instructions!



Please keep for future reference!

S65.0.01.6C-02 Operating Manual GS 150 Page 2 of 4

CONTENTS

1 GENERAL NOTE 2
2 SAFETY 2

2.1 INTENDED USE 2

2.2 SAFETY SIGNS AND SYMBOLS 2

2.3 REASONABLY FORESEEABLE MISUSE 3

2.4 SAFETY GUIDELINES 3

3 PRODUCT DESCRIPTION 3

3.1 SCOPE OF SUPPLY 3

3.2 OPERATION AND MAINTENANCE ADVICE 3

4 CONNECTION NOTE 4
5 RESHIPMENT AND DISPOSAL 4

5.1 RESHIPMENT 4

5.2 DISPOSAL INSTRUCTIONS 4

6 SPECIFICATION 4

1 General Note

Read this document carefully and get used to the operation of the device before you use it. Keep this
document within easy reach near the device for consulting in case of doubt.

2 Safety

2.1 Intended Use

The device is a low flow rate gas sampling pump for combination with residual oxygen measuring devices
for protective gas applications.

The device must be used only according to its intended purpose and under suitable conditions.
The manufacturer will assume no liability or warranty in case of usage for other purpose than the intended

one, ignoring this manual, operating by unqualified staff as well as unauthorized modifications to the de­vice.
Any other use or use exceeding this is considered as non-conforming and leads to the expiration of any
liability or guarantee claims from the manufacturer.

Use the device carefully and according to its technical data (do not throw it, strike it, …)
Protect the device from dirt.

2.2 Safety signs and symbols

Warnings are labeled in this document with the followings signs:

Caution! This symbol warns of imminent danger, death, serious injuries
and significant damage to property at non-observance.

Attention! This symbol warns of possible dangers or dangerous situa­tions which can provoke damage to the device or environment at non­observance.

Note! This symbol point out processes which can indirectly influence
operation, possibly cause incorrect measurement or provoke unfore­seen reactions at non-observance.