Greenheck Grease Trap User Manual

Document 476370

Grease Trap Installation

Curb Cap and Hinged Frame

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage!

General Safety Information

Follow all local codes, as well as the National Fire Protection Agency (NFPA), where applicable.

NFPA 96: Upblast fans shall have a

Grease Drain

Fan Curb Cap

13.75"

Center to Center

3.788"

Roof Curb

Optional Grease

Absorber

(P/N 476084)

Detail A

Parts List (per diagram)

Number Description Quantity

1 Grease Trap Assm. without Absorber (475538) 1 2 ** Grease Trap Assm. with Absorber (476085) 1 3 Flat Washer 1/4-inch x 0.75-inch 2 4 Sheet Metal Screw 1/4-inch x .075-inch 2

**This item not shown on drawing (grease trap assembly with absorber)

drain directed to a readily accessible and visible grease receptacle not to exceed 3.8 L (1 gal.)

Installation

1. Install grease absorber in grease trap (if included) then snap cover into grease trap.

2. Locate and mark the container mounting holes on the extended base or roof curb.

3. Drill 3/16-inch diameter holes in the marked locations as shown.

4. Attach container with the two supplied 1/4-inch X 0.75-inch sheet metal fasteners. See detail “A”. If extended base is a vented type, allow space between screw head and container for vent projections.

5. For most climates, ﬁll container with water (after installation and after each cleaning) until it ﬂows out the drain hole. The unit is now ready for use.

6. Check grease absorber (if included) every month. Replace grease absorber after every cleaning and/or as needed between cleanings. Grease absorber safely holds a 1/2 gallon of grease.

7. Replacement grease absorbers (P/N 476084) can be ordered from your local Greenheck Fan Representative.

Grease Trap Installation

Grease Trap Installation on Hinge Frame

1. Back out both (2) 1⁄4-20 phillips truss head screws.

2. Position grease box hooks over the screws and retighten.

Grease box hook

Parts List (per diagram)

Number Description Quantity

1 1/4-20 x 5/8 MS PTH (415729) 2

Our Commitment

As a result of our commitment to continuous improvement, Greenheck reserves the right to change speciﬁcations without notice.

Speciﬁc Greenheck product warranties are located on greenheck.com within the product area tabs and in the Library under Warranties.

Greenheck Centrifugal Upblast and Sidewall Exhaust catalog provides additional information describing the equipment, fan performance, available accessories, and speciﬁcation data.

Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: gfcinfo@greenheck.com • Website: www.greenheck.com

AMCA Publication 410-96, Safety Practices for Users and Installers of Industrial and Commercial Fans, provides additional safety information. This publication can be obtained from AMCA International, Inc. at www.amca.org.