Greenheck ERVe-20, ERVe-45, ERVe-35, ERVe Series, ERVe-55 Assembly And Installation Instructions Manual

Page 1

Document 472119

Roof Curb and Duct Adapter Assembly

Model ERVe

Assembly and Installation Instructions

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Upon receiving the product, check for any damage that may have occurred during transit and report it immediately

to the shipper. Also verify that all accessory items are accounted for.

STEP 1: Unpack and Inspect Parts

ERVe

Part Description Quantity

Roof Curb Kit

1. 14-inch 1 898453 898456 898459 898462

2. 18-inch 1 898454 898457 898460 898463

3. 24-inch 1 898455 898458 898461 898464

End Channel

1. 14-inch 2 753874 753888 753940 753954

2. 18-inch 2 753884 753900 753949 753960

3. 24-inch 2 753886 753901 753951 753962

Side Channel

1. 14-inch 2 753875 753889 753941 753955

2. 18-inch 2 753885 753901 753950 753961

3. 24-inch 2 753887 753937 753952 753963

Center Channel End Support Insulation Pan Duct Adaptor Hardware Kit

Screws, SMS (A) 12 x 0.625 (IHH) 36 415180 415180 415180 415180

1 753876 753890 753942 753956

1 753877 753891 753943 753957

2 753878 753892 753944 753958

1 753879 753893 753945 753959

1 852902 852902 852902 852902

ERVe-20 ERVe-35 ERVe-45 ERVe-55

Part # Part # Part # Part #

Roof Curb and Duct Adaptor Assembly 1

Page 2

STEP 2: Assemble Main Curb for Model ERVe

Instructions: • See ERVe Main Curb Assembly for positioning of the correct hardware.

• Align the holes and fasten as shown below.

ERVe Hardware Required:

(24) Screws, SMS (A) 12 x 0.625 (IHH)

(2) End Channels

(1) Center Channel

(2) Side Channels

(1) End Support

End Channel

Side Channels

Overall Curb Dimensions for Model ERVe

ERVe-20 ERVe-35 ERVe-45 ERVe-55

W 40.353 48.478 55.478 65.416

L 61.103 63.353 67.353 78.228

All dimensions shown are in inches.

Center

Channel

SPECIAL TOOLS REQUIRED

• Cordless drill

•

/16 in. Nut setter

• Awl — for hole alignment

End

Support

End Channel

STEP 3: Final Roof Curb Assembly for Model ERVe

ERVe Hardware Required:

(4) Screws, SMS (A) 12 x 0.625 (IHH)

(2) Insulation Pans

(1) Duct Adaptor

Insulation Pan

Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: gfcinfo@greenheck.com • Website: www.greenheck.com

All curbs shipped for ERVe units will include a duct adaptor regardless of ducting arrangement.

Duct

Adaptor

NOTE