Gree GRJW05-J Owner's Manual

Wireless Gateway Owner’s Manual

Model：GRJW05-J FCC ID:

2ADAP-W05AGL IC: 12478A-W05AGL

Gree Electric Appliances, Inc. of Zhuhai

●Pleas e read this manual carefully before operation and keep it well for future reference.

●Due to product improvement, Gree reserves the right to change contents of this manual without prior notice.

●Gree Electric Appliances, Inc. of Zhuhai reserves the final right to interpret this manual.

Dear Users:

User Notices

Please read this manual carefully before installation and operation and strictly observe the installation and operation

instructions covered in this man ual. In addition, careful atte ntio n shal l be drawn to the following symbols.

WARNING

It indicates, if operated improperly, it would lead to bodily injury or severe damage.

CAUTION It indicates, if operated improperly, it would lead to damage of unit.

WARNING

(1) Installation shall be performed by the qualified personnel; otherwise it would result in a fire hazard or electric shock.
(2) Do not place the plug of the power supply into the socket before it is dried and cleaned.
(3) Cut off the power supply of gateway before touching the electric element.
(4) Do not touch this device with wet hands, otherwise it would result in electric shock.
(5) Do use the power cord provided with the gat e wa y. A fire ha zard w ould hap pen w hen the connection or installation is
in poor condition.
(6) Do install the gateway where it will not be subject to the electromagnetic interference or heavy dust.
(7) Do install the gateway inside the electric control cabinet which is locked.

CAUTION
(1) Be sure proper power supply is provided; otherwise this device woul d w ork im prop erl y or ev en be dam a ge d.
(2) Be sure this device is setup in place; otherwise it would result in communication error.
(3) Be sure t he communic ation cabl e is co nnected to t he correct interface; otherwise it would result in comm unication

error.
(4) After connection, wires should be protected with insulation tape to avoid oxidation and short circuits.
(5) Normal working conditions: ① Temperature: -20 ～ +50℃; ② Humidity: less than 85%; ③ Location: inside the
electric control cabinet which is placed indoors, not subject to direct sunlight, rain and snow etc.