Gree GPC12AE-A3NNA8A, GPH12AE-A3NNA8A Owner's Manual

Change for Life
Owner's Manual
Portable Air Conditioner
Portable Air Conditioner
GPC12AE-A3NNA8A
GPH12AE-A3NNA8A
SUMMARY
1. SUMMARY .................................................1
. USAGE NOTICE ........................................
3--
4
7.
ACCESSORIES AND INSTALLATION OF HEAT EXHAUST HOSE
12--14
9. ELECTRIC SCHEMATIC DIAGRAM .........................16
2. WORKING PRINCIPLE.......................................1
3. STRUCTURE...............................................2
4. OPERATING METHODS ................................ 3--6
5.
.....7--9
8. CARE AND MAINTENANCE ...........................15--16
10. TROUBLESHOOTING .....................................17
11. USER NOTICES .........................................18
12. AFTER SALES SERVICE..................................19
13. INSTALLATION AND MAINTENANCE OF HEALTHY FILTER ..20
6. OPERATION OF THE REMOTE CONTROLLER
............ 10--11
.
NAMES AND FUNCTIONS OF THE REMOTE CONTROLLER
SUMMARY
1
This MOBILE AIR CONDITIONER is a small, movable air conditioner. It possessed the functions
of COOL, DRY and the Separate Ventilation, and depends on different places, it
can be moved as will.
It is fit for home and office use, especially fit for the house with many rooms.
With the compact
configuration, excellent workmanship, elegant appearance, it looks like a standing Benz car. It is
convenient for moving, energy saving, and with low noise.
Note: Please read this manual carefully before operating the unit, the manual is used for reference,
and the technical parameters are subject to change without notice.
WORKING PRINCIPLE
With the help of upper motor, the airflow of indoor pass through the evaporator becomes the
cooled wind, but with the help of lower motor, the airflow of indoor pass through the condenser
becomes the heated wind. There is two duct systems designed in its structure.The heated wind is discharged
by the rear outlet, the cooled wind is discharged by the front outlet,flow-guided by the louver,and it
brings the gentle cooling airflow,and the low temperature environment is maintained.
The Working Principle
Cooled wind
Upper motor
Lower motor
Evaporator
Airflow 1
Airflow 2
Capillary
Heated wind
Condenser
-2 -
STRUCTURE
Front
Rear
Control panel
Air outlet
Handle
Upper air inlet grille
Heat air exhaust vent
Power cord
Lower air inlet grille
16 - 30 .
The working range of COOL
mode and DRY mode
Place requirements:
OPERATING METHODS
- 3 -
. USAGE NOTICE
Unpack the Air Conditioner
Remove packaging materials
Remove and properly dispose the packaging materials. Remove tape and glue residue from surfaces before
WARNING
Excessive Weight Hazard
Use two or more people to move and install the air conditioner.
Failure to do so can result in back or other injury.
turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry it.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your air conditioner.
Place the air conditioner on a smooth level floor that strong enough to support the unit.
Allow at least 12 inches (50 cm) of air space on all sides of the unit for good air ventilation.
Place the unit in an area where the temperature will not fall below 16℃(61 ). The coils will be covered with frost at temperatures below 16(61 ), and this may reduce performance.
NOTE: The portable air conditioner has wheels for easy movement, but it should only be rolled on smooth and
flat surfaces.
Do not attempt to roll the portable air conditioner on carpet or over objects.
12 (50 cm) min.
12 (50 cm) min.
The appliance is for indoor use only,but shall not be installed in the laundry.
The Max Cooling operation temperature for the air conditioner is 35
.
The appliance shall be installed in accordance with national wiring regulations.
°
F
(86 )
°
F
°
F
°F
°F
Power must adopt the rated voltage and special circuit for AC. And diameter of power cord should be big enough.
- 4 -
Electrical Requirements
death, fire, or electrical shock.
WARNING
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Failure to follow these instructions can result in
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
Time-delay fuse or time-delay circuit breaker is recommended to be used.
All wiring must comply with local and national electrical codes and should be installed by a qualified electrician.
If you have any questions, contact a qualified electrician.
. USAGE NOTICE
OPERATING METHODS
The wiring must be operated by the professional personnel by
circuit. Don't connect earth wire to water pipe or gas pipe. When the air conditioner is not used, please pull
out the power plug or cut off power supply.
following the national regulation.There must be
electric leakage protect switch and magnetic and heat drop-off air switch that with enough capacity in fixed
Including an air switch with suitable capacity, please note the following table. Air switch should be included
20A
Air switch capacityAir-conditioner (W)
GPC12AE-A3NNA8A
GPH12AE-A3NNA8A
magnet buckle and heating buckle function, it can protect the circuit-short and overload. (Caution: please do
not use the fuse only for protect the circuit)
ON/OFF key
MODE key
COOL mode
LED screen
DRY mode
FAN mode
WATER F ULL light
Control panel and the function
1. "ON/ OFF " key
Press once to start and press once more to stop the unit.
2."MODE" key
Press this button to change the operation mode in order of: GPC12AE-A3NNA8A:
COOL → DRY FAN
COOL → DRY FAN
HEAT .
COOL ; GPH12AE-A3NNA8A:
3. key
In "COOL" or HEAT mode, press
"
""
Names and Functions Remote Controller
"
will increase
morf detceles eb nac erutarepmet ehT
Press
.
" once, the temperature will decrease 1
"once,
"
( 1 )
°
F
"
the temperature
” “ key
- 5-
OPERATING METHODS
.
1
( 1 F)
°
16
(61 )
30
( 86
°
F
°
F).
GPC12AE-A3NNA8A:
ON/OFF key
MODE key
COOL mode
LED screen
DRY mode
FAN mode
HEAT mode
” “ key
GPH12AE-A3NNA
8A
:
Loading...
+ 16 hidden pages