Gree GPC08AH-A3NNC3B, GPC09AH-A3NNC3B, GPC10AH-A3NNC3B Owner's Manual

GPC08AH-A3NNC3B

GPC09AH-A3NNC3B
GPC10AH-A3NNC3B

MODEL:

Change for Life

Portable Air Conditioner

Owner's Manual
Residential Air Conditioners

Thank you for choosing Residential

manual carefully before operation and retain it for future reference.

Air Conditioners, please read this owner’s

SUMMARY 1

WORKING PRINCIPLE

1

STRUCTURE

3

OPERATING METHODS

4

Environmental temperature

6

OPERATION OF WIRELESS REMOTE CONTROL

7

DRAINAGE METHOD 11

10

ACCESSORIES AND INSTALLATION OF HEAT EXHAUST HOSE

13

MAINTENANCE

15

Names and functions of wireless remote control

7

Guide for operation- General operation

9

MALFUNCTION ANALYSIS

16

SAFE NOTE AND NOTICE

17

AFTER SALES SERVICE

18

Functions and operation methods of control panel

Guide for operation- Optional operation

9

5

Introduction for special function

Changing batteries and notices

9

CONTENTS

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

Thank you for your selection, please read this instruction carefully before operating and keep it for consultation.

Mobile Air Conditioner is a type of small, multifunctional and movable air conditioner that contains

functions of COOL, DRY and separate ventilation, and it can be moved freely according to different

location and occasion, it is suitable for office and houses especially those with many rooms.This

product also contains the advantages of compact configuration, excellent process, elegant

appearance, convenient moving, low cost and low noise.

Note: Please read this instruction carefully before operating the unit. This instruction is only for

reference the specification parameters are subject to be changed without notice.

Under function of fan motor, indoor airflow changed into cooled air through evaporator then

blew out, while the indoor airflow changed into heated air though condenser then blew out.

There are 2 flues designed on structure of this unit: heated air is discharged from rear air outlet

vent on back air conditioner while cooled air from front air outlet vent of the unit. After guide

louver, gentle and steady cooled airflow is produced to reach needed cooling effect.

Working principle

SUMMARY

WORKING PRINCIPLE

- 1

-

evaporator

fluel

capillary

flue2

condenser

cool air

fan motor

heat air

Usage Location

1.Where room area is smaller than 15m ,and wall(or building)has well heat insulation effect.As shown

in following figure,if unit is in shown location,the cooling effect will bebetter.

2.If room area is larger than 20m ,for example workshop or factory,the unit can only offer cooled air to

partial area(as shown in following figure),and people in this area can enjoy better cooling effect.

- 2-

When only used as dehumidifier,remember to take off heat
discharge pipe from unit and install it onto unit when the unit is
used as air conditioner.Since partial indoor air will be heated
as heat air and discharged to outside by discharge pipe after
cyc-ling then outdoor air will enter to maintain balance air
pressure,thus the air conditioner will only lower temperature
of partial re-gional air of indoor room instead of turning entire
indoor air to a lower temperature.

2

2

WORKING PRINCIPLE

window or wall

discharge pipe

cooled air

Heated air

Cooling

Flow direction

of cooled air

Mobile AC

Heat air

Room

region

1.5~2m

60~70

(Sector cooling area)

Rear

Air outlet vent

Upper air inlet grille

Lower air inlet grille

Control panel

Guide louver

Swing louver

Wheel

Power

Filters

Remote conrtoller box

cord

Front

STRUCTURE

- 3-

Power

The temp.range of this unit is16 35℃ for cooli-

ng and ranges from 6

35℃ for dehumidifying

the unit.

It is better to adopt power lead with pick up current above 15A to prevent

sudden drop of voltage when the unit is running.

It is necessary to exchange broken power hose by special power hose.

When it is necessary to change power hose or maintain,please contact the

seller and have them repaired by professional personnel.

Earth must be conducted reliably and should connect to special earthing.

equipments in building to ensure well earth.

Do not replace fuse by steel or copper and capacity for fuse should be pro-

per.it is forbidden to fix power on blade or sharp objects to prevent creep-

age leaded by mangled wire.

Circuitry must be installed and fixed by professional personnel following

te national wiring regulations.Creepage protect switch with enough capa-

Place the unit on horizontal floor when using and ma-

intain a distance for above 50cm from walls,surface

of flammable objects or other obstructions.

city and.

Check before connecting power:

The normal running fluctuation range of voltage of the unit is 10% of

value listed on nameplate.Too high or too low of voltage will influence

OPERATING METHODS

15A solenoid hea t tripping air switch must be contained in circuitry. It is forbidden to connect earth

wire to water pipe or gas pipe,plug off power plug or cut off power supply when the unit is not going

to be used.

Earth

Power must contain reliable earth wire

Gas pipe

Water pipe

- 4-

Applyrange for COOL and DRY

Disposal requirement