Great Planes GPMA6004 User Manual

™

Assembling Your FlyLite Rx-R

™

Thank you for purchasing the Receiver-Ready version of the ElectriFly™ FlyLite™ model. Your model
comes equipped with two servos, a brushless motor, and a brushless ESC. All you need to do is add
your receiver and a battery, and follow these simple instructions.

1. Follow steps 3 and 4 on page 6 of the ARF

❏

manual to fi t the landing gear and prepare the
battery tray.

4. The following two LiPo battery choices are

❏

now available. If you want to use the larger 640mAh
battery, use a hobby knife to trim the side wall of the
battery compartment to allow for easy installation

2. Connect the elevator servo to the elevator

❏

and removal of the battery.

channel on your receiver. Connect the rudder servo
to the aileron channel on the receiver. Connect
the ESC signal lead to the throttle channel on the
receiver. Test for proper operation of all servos and

● Preferred for Indoor Flying

ElectriFly LiPo 300mAh, 2S, 7.4V, 20C BP series

(GPMP0700)

the motor. If the motor rotates the wrong direction,
unplug and swap the position of any two motor wires.

Then, mount your receiver in the model using the

piece of double-sided foam tape that was provided

● Preferred for Outdoor Flying

ElectriFly LiPo 640mAh, 2S, 7.4V, 15C BP series

(GPMP0704)

in this kit.

3. To fi nish assembly and set up of this model,

❏

please complete all of the steps in the ARF manual

starting on page 10 at the sub-heading, “Mount the

Horizontal and Vertical Stabilizers.”

© 2010 Hobbico®, Inc. GPMA6004 Mnl