Great Plains Inner Pivot Shear User Manual
Great Plains Mfg., Inc.
Installation Instructions
Front Fold Boom Sprayer
Inner Pivot Shear Update
Used with:
• TSF 1080
• TSF 1090
• TSF 1280
• TSF 1290
General Information
When you see this symbol, the subsequent instructions and
warnings areserious- follow without exception. Your life and
!
!
the lives of others depend on it!
These instructions explain how to install the Inner
Pivot Shear Kit.
These instructions apply to:
506-264A Inner Pivot Shear Kit TSF90
Manual Update
Refer to the Front Fold Boom Sprayeroperator’s
manual for detailed information on safely operating, adjusting, troubleshooting and maintaining
the Inner Pivot Shear Kit. Refer to the parts manual for part identification.
500-641M Operator’sManual
500-641P Parts Manual
Assembly Instructions
Refer to the drawing on the next page.
1. Unfold and support the inner booms. They will
needtobe disconnected completely.Removethe
tilt cylinder pin from the top of the pivot tube and
the tilt pivot pin (39) from the bottom of the pivot
tube.
Before You Start
Page3is a detailed listing of partsincludedin the
InnerPivotShearUpdatepackage.Use this list to
inventory parts received.
Tools Required
• Basic hand tools
Definitions
Right-hand and left-hand as used in this manual
are determined by facing the direction the machine will travel while in use unless otherwise
stated.
4. Take the replacement pivot tube shear bolt assembly and place it on the lower pivot pin (10).
Replace the upper pivot pin (4), shims (3) and
thrust washer (6). Make sure the pivot tube is
free to rotate.
2. Unbolt the upper pivot pin (4) at the top of the pivot tube, remove the shims (3), and lift out. Removethe pin (16) fromtheinner foldcylinder(17)
and swivel the cylinder away from the pivot post.
3. Liftupon the pivotpost(11)andremoveit. Leave
the lower pivot pin in place.
© Copyright 20004 Printed
9/21/2004
5. Reconnect the inner fold cylinder to the pivot
tube shear plate. Position the inner boom on the
pivot tube and replace the tilt pivot pin (39). Reconnectthetilt cylinder to the lug at the top of the
pivot post.
6. Make sure all bolts are in Place and tightened.
506-254M
Inner Pivot Shear Update
2
Great Plains Mfg., Inc.
21805
506-254M 9/21/2004
Loading...