Great Northern Popcorn 4104 GNP User Manual

Hot Dog Roller Cover Assembly Manual

Shown:
4092 GNP 7 Roller with Cover

4089 GNP Hotdog 5 Roller Cover

For use with 4091 GAP 5 Roller with Cover / 4090 GAP 5 Roller

4088 GNP Hotdog 7 Roller Cover

For use with 4092 GNP 7 Roller with Cover / 4078 GNP Hotdog 7 Roll Machine

4087 GNP Hotdog 9 Roll Cover

For use with 4093 GNP 9 Roller with Cover / 4079 GNP Hotdog 9 Roll Machine

4104 GNP 11 Roller Cover

For use with 4106 GNP 11 Roller with Cover / 4094 GNP 11 Roller Machine

Copyright © 2012 DTX International

Hot Dog Roller Cover Assembly

Please review the parts list above
and ensure that you have all the
parts necessary to complete assembly.

Should you have any difficulty assembling
your cover or mating it to your Great
Northern Popcorn Company Hot Dog
Roller, please call our customer service
line at [phone], or email us at
[e-mail].

2

Copyright © 2012 DTX International

Hot Dog Roller Cover Assembly (Cont.)

1) Remove the four screws, two on each side,
from the top inner area of the hot dog roller.
See figure 1.

Figure 1

2) Place the back side glass mount (C) onto the
machine and reinsert the screw. Do not tighten
down the screw at this time because we may
need to move it forward of back in a later step.
See figure 2.

Figure 2

3) Repeat step two for the other side rear glass
mount (F) and the two front glass mounts(D&G).
Remember not to tighten down the screws just yet.

See figure 3.

4) Place one of the glass side panels (A)
into one set of glass mounts. The mounts
may need to be moved forward or back to get
a snug fit. Once the fit is snug you may tighten
down the screws to hold the glass securely.
Repeat for the other side. See figure 4

Figure 3

Figure 4

3

Copyright © 2012 DTX International

Hot Dog Roller Cover Assembly (Cont.)

5) Slide the curved top glass (B) into the
rear side glass mounts and push all the
way down.

Ensure the edge of the curved top glass
and the edge of the side glass are flush.

See figure 6.

Figure 5

If the glass seems too snug you may need to
loosen one of the screws holding the rear side
glass mounts. Once the top glass is in place,
tighten the screw back down again.

See figure 5.

Figure 7

7) Finally, secure the front stainless trim
rail to the side glass with the nuts and bolts
(H). See figure 8.

NOTE: Be sure to NOT over tighten the nuts
and bolts, as this might crack the glass.

Figure 6

6) Set the front stainless trim rail (E) onto
the edge of the top glass. Ensure that the
holes in the ends of the trim rail line up with
the holes in the top corners of the side
glass (A). See figure 7.

Figure 8

4

Copyright © 2012 DTX International