Grandstream Networks Multiple UCM6510 IPPBX How To Interconnect

Grandstream Networks, Inc.

How To Interconnect Multiple UCM6510 IPPBX

How To Interconnect Multiple UCM6510 IPPBX Page 1 of 8

Index

Table of Contents

OVERVIEW ................................................................................................ 2

CONNECT TWO UCM6510 USING PEER SIP TRUNK ............................. 3

CREATE PEER SIP TRUNK FOR UCM6510 ........................................................................................ 3

CONFIGURE OUTBOUND RULE ON UCM6510 ................................................................................. 5

CONFIGURE INBOUND RULE ON UCM6510 ..................................................................................... 7

Table of Figures

Figure 1: SIP Trunk - Create New SIP Trunk ................................................................................................ 3

Figure 2: SIP Trunk - Set Enable Qualify ...................................................................................................... 4

Figure 3: SIP Trunk - Trunk Status ................................................................................................................ 4

Figure 4: Outbound Rule - Create New Outbound Rule ............................................................................... 6

Figure 5: Inbound Rule - Create New Inbound Rule ..................................................................................... 7

This document is subject to change without notice. The latest electronic version of this document is
available for download here:

http://www.grandstream.com/support

Reproduction or transmittal of the entire or any part, in any form or by any means, electronic or print, for
any purpose without the express written permission of Grandstream Networks, Inc. is not permitted.

How To Interconnect Multiple UCM6510 IPPBX Page 2 of 8

OVERVIEW

This document describes basic configuration to interconnect two UCM6510s. In this example, we will be
using two UCM6510s and name them UCM6510-A and UCM6510-B for the following illustration. This is
typically applied to the scenario where users would like to have UCM6510s share trunks as well as calls
from one UCM6510 extension to the other.