Mobile Lubrication Library
Wheel Loader
Suggested wheel loader automated lubrication system layout
Kit No.: 24R376, G3, USP, 22PT
333502B
Maximum System Working Pressure: 3000 psi (206 bar, 20.7 MPa)
Important Safety Information
Read all warnings and instructions in all
related manuals. Save all instructions.
Fluid leaks from incorrectly installed or ruptured compo-
Related Manuals
Manual No. Manual Title
3A0414 G3 Pump
3A0525 Pressure Relief Valve
3A0528 Remote Manual Run
3A0860 USP Valves
The information contained in this document is only a recommendation for an automatic lubrication system and is not intended to
replace the installation and maintenance instructions provided by the original equipment manufacturer.
nents, and/or failure to verify the components are properly installed and tested, can result in serious injury such
as fluid spraying in the eyes or on skin and fluid injection,
or equipment damage.
To prevent injury or equipment damage, installation must
be done by a professional and tested prior to use. Consult Parker literature for specific hose assembly instructions. These instructions are available from your Parker
representative or at www.Parker.com/pdf.
Mobile Lubrication Library
Suggested Lube Points
USP Valves
LUBE POINT INFORMATION
Pressure Relief
To Lube Points
USP
Valve
G3
Pump
To Fuse/Power
Manual Run
Button
Lube Point USP Outlet Bearing Description USP Block
1 5 Bucket connection pin right SB#2 Double
2 1 Bucket cylinder head center SB#2 Single
3 6 Bucket connection pin left SB#2 Double
4 4 Bucket cylinder foot center SB#2 Single
5 2 Center H pin SB#2 Single
6 3 Arm cylinder head center SB#2 Single
7 7 and 8 Bucket arm pivot pin left SB#3 Double
8 9 and 10 Bucket arm pivot pin right SB#3 Double
9 1 Bucket arm pin right top SB#3 Single
10 2 Bucket arm pin left top SB#3 Single
11 11 and 12 Arm cylinder foot center SB#3 Double
12 3 Pivot pin left SB#3 Single
13 4 Pivot pin right SB#3 Single
14 5 Articulation cylinder head left SB#3 Single
15 6 Articulation cylinder head right SB#3 Single
16 7 and 8 Articulation cylinder foot right SB#4 Double
17 9 and 10 Articulation cylinder foot left SB#4 Double
18 1 Articulation pivot left SB#4 Single
19 2 and 3 Articulation pivot center SB#4 Double
20 4 Articulation pivot right SB#4 Single
21 5 Differential SB#4 Single
22 6 Differential SB#4 Single
Mobile Lubrication Library
USP Volume
Dispense
Typical Pump Installation
24R376: Recommended Kit Parts List
Part Number Description
96G112 PUMP, G3-G-24MX-8L0L00-UDMVA1R2 (see manual 3A0414)
571036 KIT, accessory, cover
571028 KIT, accessory, pressure relief (see manual 3A0525)
24E407 KIT, valve, USP, 8 outlet (see manual 3A0860)
24E408 KIT, valve, USP, 10 outlet (see manual 3A0860)
24E409 KIT, valve, USP, 12 outlet (see manual 3A0860)
571033 KIT, remote manual run, 24V, w/ cable (see manual 3A0528)
24N007 KIT, accessory, mounting, USP, 6-8
24N008 KIT, accessory, mounting, USP, 10-12
16U586 KIT, accessory, hose, 100 ft
556773 HOSE, end female swivel SAE 4 JIC
556763 FITTING, 4 JIC 1/8 pm
555749 CONNECTOR, 4 JIC 1/8 pm
557393 COUPLING, 1/8 fp x 1/8 mp x 1-1/4 HEX
556402 FITTING, 1/4 x 1/8 nptf hex
557349 PLUG, dryseal 1/8 nptf
16U587 KIT, accessory, guard, scuff, 75 ft
15K783 FITTING, elbow, street, 1/8
127009 TIE, cable, 14.75’ x .31” black
16U982 KIT, accessory, hose, 200 ft
16U983 KIT, accessory, guard, scuff 160 ft
24F467 PLUG, USP, doubling plug
557944 CLAMP, 7/16, tube 4TS6-14002
127012 CLAMP, hose, .375 OD hose
563178 COUPLING, extension 1/8 female to 1/8 male
127013 FITTING, swivel, JIC 37D size #4
Mobile Lubrication Library
Qty
1
1
1
1
1
2
1
1
3
1
8
24
30
22
1
4
1
5
4
1
1
17
20
20
4
44
USP VALVES* AND ACCESSORIES
Part Number Description
24E406 KIT, valve, USP, 6 outlet
24E410 KIT, valve, USP, 14 outlet
24E411 KIT, valve, USP, 16 outlet
24N007 KIT, mounting bracket, 6-8 outlets
24N009 KIT, mounting bracket, 14-16 outlets
*see manual 3A0860
Graco Information
For the latest information about Graco products, visit www.graco.com.
TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor.
Phone: 612-623-6928 or Toll Free: 1-800-533-9655, Fax: 612-378-3590
All written and visual data contained in this document reflects the latest product information available at the time of publication.
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2013, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
Graco reserves the right to make changes at any time without notice.
For patent information, see www.graco.com/patents.
Original information. This manual contains English. MM 333502
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
www.graco.com
August 2013, revised January 2014
Loading...