Graco InvisiPac HM25 Tank-Free Instructions - Parts Manual

Instructions - Parts

ti21918a

InvisiPac™ HM25 Tank-Free™

Mounting

407070C

Adapter Plate Kit

For installing InvisiPac in place of an existing hot melt applicator system. For professional
use only.

Not approved for use in explosive atmospheres or hazardous locations.

Important Safety Instructions

Read all warnings and instructions in InvisiPac
system manual 3A2347. Save all instructions.

EN

Parts Installation

1101

1102

1103

ti21918a

A

C

B

Bolt Hole Dimensions

A 9.8 in. (249 mm)
B 14.843-15.157 in.

(377.0-385.0 mm)

C 17.003-17.317 in.

(431.9-439.9 mm)
D 23.0 in. (584.2 mm)
E 13.0 in. (330.2 mm)

Plate Extension
Dimensions

F 0.99 in. (25.1 mm)
G 0.58 in. (14.7 mm)
H 1.58 in. (40.1 mm)
J 3.36 in. (85.3 mm)

1104

A

D

E

F

G

J

H

1. Remove existing hot melt applicator system.

2. Use six screws (1102) and six nuts (1103) to secure
adapter plate (1101) through the existing holes from
the previous system.

3. Align the InvisiPac system with the bolts on the
adapter plate (1101) then place onto the adapter
plate (1101).

4. Use the remaining three nuts (1103) to secure the
InvisiPac system to the adapter plate (1101).

5. Use elbow fitting (1104) to install system air inlet
filter (A, not included with kit).

Graco Information

Sealant and Adhesive Dispensing Equipment

For the latest information about Graco products, visit www.graco.com.
For patent information, see www.graco.com/patents.

TO PLACE AN ORDER, contact your Graco distributor, go to www.graco.com and select
“Where to Buy” in the top blue bar, or call to find the nearest distributor.

If calling from the US: 800-746-1334
If calling from outside the US: 0-1-330-966-3000

Ref Part Description Qty

1101 --- PLATE, adapter 1
1102 112395 SCREW flange head cap 6
1103 112958 NUT, hex, flanged 9
1104 121283 FITTING, elbow, 45 degree 1

All written and visual data contained in this document reflects the latest product information available at the time of publication.

GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA

Copyright 2013, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.

Graco reserves the right to make changes at any time without notice.

Original instructions. This manual contains English. MM 407070

International Offices: Belgium, China, Japan, Korea

Graco Headquarters: Minneapolis

www.graco.com

Revision C, January 2017