Instructions
TI8213b
9902471
Class I, Div 1,
Group D T3A
Models with DataTrak™ include
agency approvals listed below.
2575
II 1 G
Ex ia IIA T3 Ga
ITS13ATEX27862X
DataTrak
™
Conversion
Kit
For converting NXT Air Motors to include the DataTrak module.
Part No. NXT606 Kit, for NXT Model 6500 Air Motors
Part No. NXT306 Kit, for NXT Model 3400 Air Motors
Part No. NXT206 Kit, for NXT Model 2200 Air Motors
Important Safety Instructions
Read all warnings and instructions in this manual
and in the NXT air motor manual 311238.
Save these instructions.
311486E
EN
Installation
WARNINGWARNINGWARNING
WARNING
Battery
TI7757a
Solenoid Cable Connection
Sensor Cable Connection
Strain Relief
A
B
CD
E
F
TI8396b
Installation
SPECIAL CONDITIONS FOR SAFE USE
Equipment must comply with the following
conditions to avoid a hazardous condition
which can cause fire or explosion.
• All label and marking material must be
cleaned with a damp cloth (or equivalent).
• The electronic monitoring system is
required to be grounded. See Ground-
ing instructions in the NXT air motor
manual.
Install the Battery
Disassembly
1. Stop the pump during the upstroke. Relieve the
pressure, see the NXT air motor manual.
2. Disconnect the air line to the motor.
3. See F
IG. 2. Pry off the top cover (A) and discard.
Remove the air valve cover (B), solenoid clip (C),
and screws (D); keep for reuse. Remove and
discard the solenoid plug (E) and o-ring (F).
1. Take the DataTrak™ module (1) to a non-hazardous
location.
2. Install the battery, see F
Graco-approved battery, see the NXT air motor
manual.
IG. 1. Always use a
FIG. 2. Disassembly
F
IG. 1. Battery Location and Module Cable
Connections
2 311486E EN
Loading...