Graco 3A1653A User Manual

Instructions

Bottom Feed Fittings Kit for RoadLazer™ RoadPak

Model 24J149

75 psi (0.5 MPa, 5 bar) Maximum Working Pressure

Important Safety Instructions

For complete warnings and safety instructions see RoadLazer™ RoadPak

™

Line Striping System

- For use with waterborne paints -

™

Line Striper System manual. Save these instructions.

3A1653A

ENG

ti17198a

Installation

1. Drill a 3 in. hole in the bottom of the tank that the bottom feed fittings are being installed into.

ti17210a

Parts

2. Assemble gasket (4) to fitting (5) and insert through 3 in. hole as shown below.

ti17211a

3. Tighten nut (3) to securely fasten the fittings to the tank. Screw in barbed fitting (2) to (5). NOTE: Be sure to install fitting (2) aimed in desired direction.

4. Assemble 1.5 in. ID hose to barbed fitting and secure with a clamp.

ti17199a

Ref. Part Description Qty.

1 125141 FITTING, thru-wall blkhd, 1-1/2 in. 1 2 125142 FITTING, 90 elbow, 1-1/2 in. x barb 1 3 125145 NUT, 1-1/2 in. poly tank flange 1 4 125143 GASKET, 3 in., fkm 1 5 125144 BODY, 1-1/2 in. poly tank flange 1

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

Original instructions. This manual contains English. MM 3A1653

Graco Headquarters: Minneapolis

International Offices: Belgium, China, Japan, Korea

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441

www.graco.com

Revision A - 04/2011