Graco 3A1585B User Manual

Instructions
ThermoLazerâ„¢ Die Heat Retrofit Kit
Model 24H620
- For professional application of thermoplastic traffic marking compound materials (reflective beads applied simultaneously with screeding) -
- For outdoor use only (not to be operated in rain or damp conditions) -
Read all warnings and instructions in manual 3A1319. Save these instructions.
3A1585B
EN
ti22971a
Installation
1. Disconnect propane source.
ti14128a
4. Apply sealant to male threads on tee.
ti17138b
5. Assemble tee to regulator and orient as shown (18mm and 20mm).
ti17144a
2. Close valve by torch regulator.
ti14602a
3. Disassemble torch hose from regulator (15mm and 20mm)
ti17141b
6. Apply sealant to torch hose threads.
ti17140a
7. Assemble torch hose to tee (15mm and 18mm).
ti17143b
ti17142a
2 3A1585B
8. Disassemble bead dispenser bracket bolts (19mm) from ThermoLazer.
ti17145a
9. Slide die heat kit over bead dispenser. Align slot on bracket with bead dispenser screw head as shown. Bolt hole should also be aligned.
11. Route hose as shown below.
ti17148b
12. Attach hose swivel to tee fitting (21 mm).
ti17146a
10. Assemble bead dispenser bracket bolts to unit. These bolts hold the die heat kit to the unit.
ti17145a
ti17147b
13. Install screed box rear burner lighting instructions label on screed shroud dorr below the torch lighting instruction label.
ti14144b
3A1585B 3
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 3A1585
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2008, Graco Inc. is registered to I.S. EN ISO 9001
www.graco.com
Revision B - January 2014
Loading...