Graco 3625 User Manual

2 4
© 1999 Graco 226-10-99 IS3556
Failure to follow these warnings and the assembly instructions
could result in serious injury or death.
Congratulations on your purchase of a Graco
®
Graco is the recognized leader in the design and manufacture of quality baby products. We believe your new Graco
®
highchair is a wise choice, promising many hours of enjoyment for your baby.
Before using your highchair, please take a few minutes to read this Owners Manual. The short time you spend reading these instructions will help you to use your highchair properly.
Please save your Owners Manual
for future use.
Customer Satisfaction
Our goal is to make every product the best it can be! We are also committed to supporting our products after purchase. If you would like to speak to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
or visit our Internet website, www.gracobaby.com. Our knowledgeable staff will be ready to answer any questions you may have concerning parts, use, or maintenance. When you call, please have the model and serial numbers ready so your call may be processed quickly and efficiently.
Model 3625
Highchair
NEVER LEAVE YOUR CHILD UNATTENDED. Always keep your child in view.
Prevent serious injury or death from falls or sliding out. Always secure child in the restraint.
FOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY.
If you experience any difficulties, please contact the Customer Service Department.
THIS HIGHCHAIR IS DESIGNED TO BE USED by a child between 6 months and 3 years of age. Maximum weight 37 pounds (16.8 kg).
DO NOT FORCE TRAY against child. Use only the five adjustment positions. Be sure both adjustment fingers are engaged in armrest slots.
DO NOT ADJUST the highchair with your child in it.
OWNERS MANUAL
Model No. _______ Serial No. ________
Dear Customer,
Please fill in the model and serial numbers above from the label on the back of the footrest of your new highchair.
3
DISCONTINUE USING YOUR HIGHCHAIR should it
become damaged or broken.
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR HIGHCHAIR for
loose screws, worn parts or torn material. Replace or repair the parts as needed. Use only Graco®replacement parts.
TO CLEAN HIGHCHAIR FRAME, use only household soap or detergent and warm water. NO BLEACH.
Secure your child at all times with the restraint system provided. The tray is not designed to hold your child in the highchair. It is recommended that the highchair be used only by children capable of sitting upright unassisted.
STRANGULATION HAZARD: DO NOT place highchair in any location where there are cords, such as window blind cords, drapes, phone cords, etc.
Seat with seat belt
Tray
Front tube
Screw (4)
Seat pad
Rear tube
Bolt (2)
T-nut (2)
Upper tube
Foot (4)
Slider (2)
Support tube
PARTS LIST
CHECK that you have all the parts listed
below BEFORE assembling your highchair.
If any parts are missing, call
Customer Service at 1-800-345-4109.
Tool required: Screwdriver
5
226-10-99 IS3556
6 87
Assembling the Highchair
Step 1.
Hold front tube with ends up. Place a foot (smooth side up) at one curved corner of tube. Insert a screw through tube and into foot, then tighten. Repeat with other corner and both feet of rear tube.
Step 2.
Lay seat face down on the floor as shown. Insert support tube through both collars on bottom of seat.
Step 3.
Mount a slider onto each end of the support tube. Slider loops should be facing UP, as shown. Push end of slider all the way into collar.
Step 4.
Insert both ends of upper tube into slider loops and pull all the way through as shown.
Still holding ends of tube, locate pegs. Push pegs through the channel until they pass the snap. Slide pegs into first notch of height-adjustment track.
Step 5.
Hold rear tube as shown. Slide plastic brackets onto upper tube.
Step 6.
Slide front tube onto upper tube as far as it will go, until the holes in the tubes line up.
Step 7.
Pull rear tube up until holes in plastic bracket line up with holes in the tubes.
CHECK that holes in upper tube, front tube AND plastic brackets all line up with each other.
Insert a T-nut into one plastic bracket hole. It must pass through both tubes, as shown enlarged below. Insert a screw into other side of plastic bracket and screw it into T-nut.
CHECK that tubes are securely connected by trying to pull them apart.
Repeat for other plastic bracket.
Collars
Support tube
Pegs
First notch of
height adjustment track
Both U
curves up
U curve
down
Plastic bracket
Step 8.
Place seat pad in seat as shown. Insert tabs of seat pad into the corresponding slots in the seat. From rear of seat, hook all four tabs over plastic anchors.
To Use Seat Belt
Step 1.
Snap buckle together as shown. Adjust belt as needed to get a snug fit around your child.
Step 2.
Press on prongs at top and bottom of buckle to release.
Set highchair upright. It should look like this.
Prevent serious injury or death from falls or sliding out. Always secure your child in the restraint. Do not depend on the tray alone to hold your child.
If it becomes necessary to remove the seat belt, follow these instructions:
Step 1.
First buckle the belt. Then unthread end of seat belt through the buckle as shown.
Step 2.
Pull other end of the seat belt through the belt retainer as shown.
Step 3.
To rethread buckle, thread the free end of the waist belt back through the belt retainer. The GRACO logo must be on the front of the buckle.
Step 4.
Thread belt through the buckle as shown. The left end of the buckle must be smooth side up to thread the belt in the buckle properly. The other side of the buckle has teeth.
If you have difficulty getting the belt into the buckle, check to make sure that the smooth side of the buckle is up.
CHECK that the belt is threaded correctly by pulling on the seat belt. The belt
should not slip through the buckle.
Smooth side
9
226-10-99 IS3557
10
To Fold Highchair
Lay highchair on the floor as shown. Press in metal buttons at base of both plastic brackets. Push rear base down to fold highchair.
Pull UP
To Adjust Height
DO NOT
adjust the highchair with your child in it.
Hold chair frame down and lift seat firmly to free pegs from height­adjustment notch. Slide seat up or down in the track, then snap it into desired height setting.
When adjusting height, be careful to keep fingers away from height-adjustment track.
There are five possible height settings. The highchair can be used as a toddler chair by adjusting to the lower height settings.
CHECK that both sides of chair are snapped into the desired height-adjustment notch.
Push on
front button
To Use Tray
Place tray on armrests of seat. Pull out side handles under the tray. Put tray in one of the five adjustment positions, and release side handles.
CHECK that tray is securely attached by pulling forward on the tray.
Use either the side handles or the front button to adjust the position of the tray.
DO NOT
force the tray against your child. Keep your childs hands and fingers away from the tray when adjusting the tray.
Tray may be removed from highchair by using the side handles.
Replacement Parts
Instructions for ordering highchair parts:
Complete form below. Your highchair model number MUST be included on the form to ensure proper replacement parts.
Your model number can be found on a sticker on the back of the footrest. Payment must accompany your order.
Model Number
(Must be filled in)
SHIP TO:
Name
Address
City, State, Zip
( ) Telephone
Check enclosed (payable to Graco Childrens Products Inc.)
Charge to credit card:
Visa MasterCard Discover
Account #:
Expiration date:
Signature:
Seat Seat pad Tray Upper tube Support tube Rear tube Front tube Slider Foot Hardware
Parts List:
Seat....................................
Seat pad.............................
Tray.....................................
Upper tube..........................
Support tube.......................
Rear tube............................
Front tube...........................
Slider...................................
Foot.....................................
Hardware.............................
Price:*
$22.00 $16.00 $18.00 $ 9.50 $ 7.00 $10.00 $ 9.50 $ 5.00 $ 5.00 $ 5.00
* Prices subject to change without notice.
Return the form below with payment to:
GRACO CHILDRENS PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
IF YOU NEED HELP
If you have any questions or if you need any parts
not listed, please call toll-free:
1-800-345-4109
or visit our Internet website, www.gracobaby.com
Total:
Shipping & handling: $5.00
6% sales tax (PA only):
Total amount due:
11
Loading...