![](/html/eb/eb9d/eb9d965da173123f0e55b450aafbaa256bd81b2df1a6fcd49c169af1ef491995/bg1.png)
Husky™ 1050HP
Product Descriptor with Initial Caps and No Period
High Pressure Air-Operated Diaphragm Pump
Benefit statement of product that describes it’s function
upper and lower case that can go to two lines
• Increased fluid pressure without sacrificing flow
• Turnkey system – includes everything you need to be job-site ready
• Low-high pressure mode valve lets you operate the pump as a standard AODD or a high pressure AODD
• Better temperature control of materials which results in better yields
• Reduce air consumption up to 50% with the low pressure mode
• Solid construction – engineered to support the weight of equipment and materials
• Same repair parts as our Husky 1050 AODD reduces inventory levels
• Rugged design handles extreme job environments
• Safety features and climate control built into the design
![](/html/eb/eb9d/eb9d965da173123f0e55b450aafbaa256bd81b2df1a6fcd49c169af1ef491995/bg2.png)
HUSKY™ 1050HP
The Husky 1050HP is the first pump on the market that allows users to choose between
low pressure and high pressure operating modes with Graco’s low-high pressure mode
valve. High pressure operation isn’t always required, so switch to the low pressure mode
to reduce air consumption up to 50%. These features, combined with the quality and
reliability of our standard Husky diaphragm pump design; make this one of the most
unique high pressure diaphragm pumps on the market.
Material Options
Balls Seats Diaphragms
Application Areas
Filter Press Applications
The Husky 1050HP pump is ideal for filter
press applications. The full flow and high
pressure design allows for maximum
flow rate through the press to keep your
operation running at top capacity.
RECOMMENDED MATERIALS
Fluid Manifolds
/ Covers
Seat Santoprene or
Ball Santoprene or
Diaphragms Santoprene or
Aluminum or
Stainless Steel
Stainless Steel
Stainless Steel
2-piece PTFE
Ceramic Applications
For ceramic applications, use the low
pressure mode for the initial mold filling to
maintain process speed. Final mold pack
can be performed in the high pressure
mode to remove air pockets for a higher
finish quality.
RECOMMENDED MATERIALS
Fluid Manifolds
/ Covers
Seat Stainless Steel or
Ball Weighted Neoprene
Diaphragms Overmolded Neoprene
Aluminum or
Stainless Steel
Geolast
or Stainless Steel
or Buna
High Head Pressure or Long
Distance Applications
The high pressure mode of the Husky
1050HP is great for applications that
require additional head pressure to
pump fluid against higher pressures
or longer distances.
RECOMMENDED MATERIALS
Any material configuration can be used
as long as chemical compatibility has
been verified.