Instructions
Read and keep for reference. For detailed instructions and
warnings, see manual 309301.
Software Upgrade Kit 245248
For upgrading ProDispense™ main PCB board software
309398
Rev. A
First choice when
quality counts™
To avoid damage, keep main PCB chip in its
original packaging until you are ready to use it.
Ground yourself with the wrist strap before handling circuit board components.
Kit includes:
Description Qty.
Main PCB Chip with software update 1
Chip Extractor Tool 1
Grounding Wrist Strap 1
Replacing Main PCB Chip
To reduce the risk of fire, explosion or electric shock:
ProDispense controller must only be
•
installed and serviced by a qualified
electrician.
Turn off ProDispense power switch and
•
disconnect electrical power supply
before servicing equipment.
1. Turn off ProDispense power switch.
5. Orient the new chip with the main PCB socket and
lay it on the socket. With even pressure, snap the
chip firmly into place. When properly installed, the
top of the chip is flush with the top of the socket.
6. Reinstall control box cover.
2. Remove control box cover (A). See Manual 309301
and refer to
3. Locate PCB chip (B) on main circuit board. See
.
1
4. Remove old chip (B) with chip extractor provided.
The chip has three sharp corners and one
chamfered corner. Orient the chip’s chamfered
corner toward the socket’s chamfered corner.
Incorrect installation can damage the chip or
board.
.
. 2
F
IG
F
IG
COPYRIGHT 2001, Graco Inc.
Graco Inc. is re
istered to I.S. EN ISO 9001
FIG. 1
.
FIG. 2
A
REF B
TI1436a
Sales Offices:
International Offices:
Minneapolis, Detroit
Belgium, Korea, Hong Kong, Japan
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
www.graco.com
PRINTED IN USA 309398 July 2001