Graco 309283A User Manual

Installation Instructions

For detailed HVLP–Turbine Gun information and warnings see Operating Instructions manual 309317.

INSTRUCTIONS

Cup–Over Kit for HVLP–Turbine Guns

Cup–Over Kit 244136

Form No. 309283

Rev. A

This manual contains kit

installation instructions only.

To find your local Graco authorized service center

D Call us at 1–800–690–2894 D Visit our website at

www.graco.com

WARNING

Relieve all fluid pressure in the system before you install, remove, or replace any parts. See the Pressure Relief Procedure below or for more information refer to Operating Instructions manual

309317.

Pressure Relief Procedure

1. Turn off turbine and air supply to gun.

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441

Graco Inc. is registered to I.S. EN ISO 9001

2. Unlatch cup

2. Twist cover counterclockwise

Cup–Over Kit 244136

Removing Cup or Remote Pressure Pot

WARNING

The spray gun cup is pressurized by the gun’s air supply. To reduce the risk of serious injury from pressurized fluid or accidental spray from the gun, always turn off the air supply to the gun before you remove the spray gun cup.

1. Turn off air supply to gun.

2. Relieve pressure following the Pressure Relief Procedure provided on the front of this instruction

sheet or in manual 309317.

3. Using a needle nose pliers remove air tube from barb on bottom of gun (A)

4. Using the Graco wrench tool included with your gun, loosen cup fitting B. Detach the gun from the cup.

5. Using the Graco wrench, loosen nut C.

6. Rotate fluid house until fluid fitting D is on top of the

gun.

7. Retighten nut C using the Graco wrench tool included with your gun.

fluid housing

gun hook

Attaching the Cup–Over

1. Thread fitting E on the cup–over and fluid fitting D on

the gun together.

2. Use the Graco wrench tool included with your gun to fasten securely.

3. To ensure air tube 1 is clear of the trigger during use, before connecting the air tube to the gun barb, route it through gun hook and then connect it to gun barb.

All written and visual data contained in this document reflect the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

1 244134 TUBE kit (5/pack)

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441

3092832

www.graco.com

PRINTED IN USA 309283 01/2001