Graco 309119D User Manual

Instructions – Parts List
Pro-ShotGrease Dispense Valve Service Kit
Part No. 243446
Used on Models 242055, 242056, 242057, and 242058
10
11
309119D
Ref. No. Description Qty.
1 NUT, self-locking; 10–32 2 2 BALL, carbide 1 3 SPRING, compression 1 4 SEAL 1 5 NUT, hex; 10–32 2 6 GASKET; copper 2
GRACO INC.ąP.O. BOX 1441ąMINNEAPOLIS, MNą55440-1441
Copyright 2000, Graco Inc. is registered to I.S. EN ISO 9001
TI0629B
Ref. No. Description Qty.
7 PLUNGER/ROD ASSY. 1 8 SEAT, valve 1 9 YOKE 1 10 SHAFT, pivot 2 11 GUIDE, rod 1
Installation
See instruction manual 309032 for troubleshooting guide. Replace all parts included in this service kit, checking all parts thoroughly when disassembling, and carefully replace any additional parts that are worn or damaged.
Adjustment
2. To adjust the clearance, loosen the top nut (Fig. 1,
WARNING
To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the Pressure Relief Procedure in instruction manual
309032.
1. Relieve the pressure.
item 5) and turn the bottom nut (5) in or out as needed. Hold the bottom nut in place and securely tighten the top nut.
3. For less than maximum flow, back off bottom nut (5).
1
5
Turn adjusting nut (5) down until yoke bottoms out
1
on rod guide or until resistance is noticeably greater (max flow setting)
Yoke
Rod Guide
Torque 80 – 100 ft. lbs.
Fig. 1
All information, illustrations and specifications in this document are based on the latest product information available at the time
of publication. The right is reserved to make changes at any time without notice.
Sales Offices: Minneapolis, Detroit
International Offices: Belgium, Korea, Hong Kong, Japan
www.graco.com
PRINTED IN U.S.A. 309119 01/2000, Revised 02/2002
2 309119
TI0628
Loading...