Graco 307942E User Manual

Instructions - Parts List
®
Fire-Ball
300 Air
Motor Muffler Kit
For professional use only.
Important Safety Instructions
Read all warnings and instructions in this manual and in the Fire-Ball 300 Pumps man­ual, included with your unit. Save all instruc­tions.
307942E
EN
NOTICE
You cannot order parts or request service and war­ranty information for the complete pump without the information on the serial label.
Record all information from the serial label in the space provided below. Keep this manual in a safe place as an extra precaution.
GRACO PUMP
PART NO.
SERIAL
MAX AIR WPR
MAX FLUID WPR
MPA bar psi
MPA bar psi
SERIES

Service

Service

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see this symbol.
This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment.
1. Close the pump air regulator and bleed-type master air valve (required in the system).
2. Hold a metal part of the dispensing valve firmly to a grounded metal waste container and trigger the valve to relieve the fluid pressure.

Replace the Muffler Plates

NOTE: You cannot order parts or request service or
warranty information without the serial label information. Record the serial label (A) information on the front of this manual as an added precaution. Keep the manual in a safe place.
1. Unscrew the plate retaining screw and remove the identification muffler plate and warning muffler plate from both sides of the air motor. To avoid twisting the screw heads off if the screws are hard to remove, tap lightly on the screw heads with a ham­mer then remove them.
2. Discard the old identification muffler plate and warn­ing muffler plate. The muffler kit includes an identifi­cation plate for one side and a warning plate for the other side.
3. Install the two mufflers (1, 2) on the air motor as shown on the parts drawing. Fasten the mufflers to the air motor, using the plate retaining screws (3).
4. With the air motor operating, check all around both mufflers for air leaks, Adjust the plate retaining screws if necessary.
2 307942E
Loading...
+ 2 hidden pages