GPX C232B User Manual

USER’S GUIDE

V:1349-0105-12

C232B Clock Radio with Dual Alarm

FCC Warnings

Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Introduction and Setup

Power

Plug the included AC/DC power adapter into the DC POWER INPUT on the dock and an AC power outlet to power the dock.

PM Indicator

Lights when the time

is in the PM.

Dimmer

Press to dim the

display.

Tuning/Min/Hour

Press to tune the

radio.

Press to adjust the

minute or hour when

setting the clock or

alarm.

Battery Backup

The battery backup is intended for short power outages only. The clock radio’s primary functions cannot run off of the battery backup alone.

Requires 2, AAA-size, batteries (not included)

LED Display

Alarm 1 Buzzer/

Radio Indicator

Lights when the

alarm 1 is on and set

to buzzer or radio.

alarm 2 is on and set

to buzzer or radio.

Alarm 2 Buzzer/

Radio Indicator

Lights when the

Clock/Mem

In Off mode, press

and hold to begin

setting the time.

In radio mode, press

to cycle through

preset stations.

Snooze/Sleep

Press to snooze the

alarm after it sounds.

Press repeatedly to

set the sleep timer.

Volume/AL1/AL2

Press to adjust the

volume.

Press to begin

setting Alarm 1 or

Source/AL Off

Press and hold to turn off the radio.

Press to turn off the

alarm.

Alarm 2.

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215

Clock and Sleep Timer Alarm Radio

Setting the Clock

1. If in radio mode, press and hold the Source/Al Off button to turn the unit off.

2. Press and hold the Clock/Mem button until the display begins to blink, then release the button.

3. Press the Hour button to adjust the hour.

The PM indicator will light when the hour is set in the PM.

4. Press the Min button to adjust the minute.

5. Press the Clock/Mem button to nish setting the time.

Setting the Sleep Timer

1. Follow the instructions for v.

2. Press the Snooze/Sleep button repeatedly to set the sleep timer ( 90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF ).

3. Once the set sleep time has expired the clock radio will automatically power off.

Setting the Alarm

1. If in radio mode, press the Source/Al Off button to turn the unit off.

2. Press and hold the Al1 or Al2 button until the display begins to blink, then release the button.

3. Press the Hour button to adjust the hour.

The PM indicator will light when the hour is set in the PM.

4. Press the Min button to adjust the minute.

The Alarm 1 or Alarm 2 indicator will come on.

5. Press the Al1 or Al2 buttons repeatedly to switch between Radio and Buzzer.

If the alarm is set to Radio, use the Vol+/- buttons to adjust the volume of the alarm.

6. Once the set alarm time is reached, the alarm will sound.

To set the other alarm, follow the above steps and choose the alarm not currently set.

Cancelling the Alarm

1. Follow the instructions for Setting the Alarm.

2. Press the Al1 or Al2 buttons repeatedly until the indicator is no longer lit.

Snooze and Alarm Reset

After the alarm sounds:

Press the Snooze/Sleep button to delay the alarm for an additional 9 minutes.

Press the Source/Al Off button to turn the alarm off until the set alarm time is reached again.

Tuning the AM or FM Radio

1. Press the Source/Al Off button

2. Press the Source/Al Off button

3. Press the Tun+ and Tun-

4. Press and hold the Tun+ and

5. Press the Vol+/- buttons to

6. Press and hold the Source/Al

Saving a Station as a Preset

1. Follow the instructions for

2. Tune to the desired station.

3. Press and hold the Clock/Mem

Tuning to a Preset Radio Station

1. Follow the instructions for

2. Press the Clock/Mem button

Radio Reception

Adjust the position of the FM Antenna to improve FM radio

reception.

An AM antenna is built into the clock radio. To improve AM radio reception, adjust the position of the clock radio.

to turn the clock radio on.

again to switch between the AM and FM radio mode.

buttons to adjust the radio to the desired frequency.

Tun- buttons to search for the next available frequency.

adjust the volume.

Off to turn the radio off.

Tuning the AM or FM Radio.

button to save the current radio station as a preset.

Tuning the Radio and Saving a Station as a Preset.

to cycle through preset radio stations.

International Support

To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at:

www.gpx.com

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215

Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección de apoyo en

www.gpx.com

Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des questions fréquemment posées, consultez la rubrique d’assistance sur

www.gpx.com