Gorenje TG 30 N, TG 100 N, TG 80 N, TG 120 N, TG 50 N Installation Instructions Manual

TG 30 - 200 N

EN

7

Dear buyer, we thank you for purchase of our product.

Prior to installation and f rst use of the electric water heater, please carefully read
these instructions.

This water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the Safety Certif cate and the
Electromagnetic Compatibility Certif cate. The technical characteristics of the product are
listed on the label aff xed between the inlet and outlet pipes. The installation must be carried
out by qualif ed staff. All repairs and maintenance work within the water heater, e.g. lime
removal or inspection/replacement of the protective anticorrosion anode, must be carried out
by the authorised maintenance service provider.

BUILDING-IN

The water heater shall be built-in as close as possible to the outlets. When installing the
water heater in a room with bathtub or shower, take into account requirements def ned in IEC
Standard 60364-7-701 (VDE 0100, Part 701). It has to be f tted to the wall using appropriate
rag bolts with minimum diameter of 8 mm. The wall with feeble charging ability must be
on the spot where the water heater shall be hanged suitably reinforced. The water heater
may be f xed upon the wall only vertically. We recommend the distance between the water
heater and the ceiling is large enough to allow simple replacement of the MG anode (see
dimension G in the Installation Drawing), in order to avoid unnecessary dismounting of the
heater during the servicing intervention.

TECHNICAL PROPERTIES OF THE APPLIANCE

Type TG 30 N TG 50 N TG 80 N TG 100 N TG 120 N TG 150 N TG 200 N

Model TG 30 N TG 50 N TG 80 N TG 100 N TG 120 N TG 150 N TG 200 N
Volume [ l ] 30 50 80 100 120 150 200
Rated pressure [ MPa] 0,6
Weight / Filled with water [ kg ] 20/50 24/74 30/110 34/134 38/158 44/194 70/270
Anti-corrosion protection of tank Enameled / Mg Anode
Connected power [ W ] 2000
Voltage [ V~ ] 230
Heating time to 75°C

1)

[ h ] 1

05

1

55

3

05

3

55

4

35

5

45

7

40

Quantity of mixed water at 40°C [ l ] 50 89 145 200 236 298 399
Energy consumption

2)

[kWh/24h ] 0,90 1,32 1,85 2,20 2,60 3,20 2,80

1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature of
cold water from water supply 15°C.

2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding
temperature 20°C, measured according to DIN 44532.