Goodmans GFMTDAB10 User Manual
GFMTDAB10
In-Car DAB Adaptor
User Guide
IMPORTANT:
Please read all instructions carefully before use and keep for future use
Introduction
Thank you for purchasing this Goodmans In Car DAB Adaptor.
Not only does it receive DAB radio stations and transmit them to your In Car Audio system using
an in-built FM transmitter,you can also connect an auxiliary device to it.
Safety is important
Use of any electrical equipment should be undertaken with care. Please read the safety
section on page 14 before using this In Car DAB Adaptor.
2
What’s in the box?
What’s in the box
03
DAB Transmitter
Goodmans
GFMTDAB10
In Car DAB Adaptor
User Guide
Please read all instructions carefully before use and keep for future use
IMPORTANT:
Manual 12/24V- 5V DC In Car Adaptor
”The antenna shown may differ slightly to the one supplied”
Windscreen Mount
Antenna
Contents
01 Your In-Car DAB adaptor .................................................................................
02 Get Going ......................................................................................................
03 Daily Use .....................................................................................................
04 Troubleshooting Guide ..........................................................................................
05 Specifications .....................................................................................................
06 Warnings .......................................................................................................
07 Guarantee .......................................................................................................
4
5
7
12
13
14
15
3
Your In Car DAB Adaptor
01
Select Button
Scroll Wheel
Power
Button
AUX input
Connector
Menu
Button
Power
Connector
DAB Scan
Button
Best Frequency for
FM Transmission
Graphical LCD
Display
PRESET
Buttons
Antenna
Connector
4
Get Going
Install the Antenna
1
Select a suitable location for the antenna. This can either be at one side of the front
windscreen, as shown, or a suitable non-opening rear window. Note that the antenna
cable is 2.0m in length. For best results, position the aerial wires 2-3 cms from the edge
of the glass.
Peel the backing off the antenna and attach the antenna to the inside of the window,
ensuring it is clean and dry before you do so. It is only designed to be used once, and if
removed, will not re-adhere to the glass.
02
2
Connect the Antenna
Run the antenna lead along the trim so it is not showing if possible, and attach to the
unit by screwing the antenna connector onto the antenna jack on the side of the unit.
Screw it up tightly using fingers only.
Don't Forget! A spanner is not necessary.
3
Attach mount to the windscreen
Clean the area you have chosen with a dry cloth then peel off the transparent film from
the suction cap. Press the suction cap firmly onto the windscreen and push down the
catch to securely fasten the mount to the windscreen.
5
Loading...