How it Works
Gold Medal Products
Loading...
2388EX
Operators Manual
11 pgs1.11 Mb0

Gold Medal Products 2388EX Operators Manual

Econo 8 Model No. 2388, 2388EX
Light And Warmer Switch Part No. 42532 (2)
Kettle Motor Switch Part No. 42532 (2)
Kettle Heat Switch Part No. 42798 (1)
INSTALLATION AND OPERATING INSTRUCTIONS
CHECKING SHIPMENT
Unpack all cartons and check thoroughly for any damage which might have occurred in transit. Damage
claims should be filed immediately with the transportation company.
2388: 120V, 60Hz, 1525W 2388EX: 230V, 50Hz 1525W
If in doubt, your electrician must furnish sufficient power for proper machine operation. We recommend this popper be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
INSTALLATION
Your Econo 8 Popper was adjusted, inspected, and tested before it left the factory. Remove all packing before setting up your new Econo 8. Hang the kettle on the hanger assembly attached to the celling of your Econo 8. Finally, make sure to plug the power cord into the power receptacle located on the celling of your popper.
CONTROLS AND THEIR FUNCTIONS
LIGHT AND WARMER SWITCH – Turns on the heat to the bottom corn pan and heat light. KETTLE MOTOR SWITCH – Turns on the motor which drives kettle agitator shaft. KETTLE HEAT SWITCH – Turns on the heat element
AMOUNT OF POPCORN AND OIL
Your new Econo 8 is equipped with a corn measuring cup (Part No.47147). Corn charge – 8 oz. Oil charge – 2.4 oz. Flavacol – 1 1/2 teaspoon
POPPING INSTRUCTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
http://www.gmpopcorn.com Page 3
Econo 8 Model No. 2388, 2388EX
Light And Warmer Switch Part No. 42532 (2)
Kettle Motor Switch Part No. 42532 (2)
Kettle Heat Switch Part No. 42798 (1)
INSTALLATION AND OPERATING INSTRUCTIONS
CHECKING SHIPMENT
Unpack all cartons and check thoroughly for any damage which might have occurred in transit. Damage
claims should be filed immediately with the transportation company.
2388: 120V, 60Hz, 1525W 2388EX: 230V, 50Hz 1525W
If in doubt, your electrician must furnish sufficient power for proper machine operation. We recommend this popper be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
INSTALLATION
Your Econo 8 Popper was adjusted, inspected, and tested before it left the factory. Remove all packing before setting up your new Econo 8. Hang the kettle on the hanger assembly attached to the celling of your Econo 8. Finally, make sure to plug the power cord into the power receptacle located on the celling of your popper.
CONTROLS AND THEIR FUNCTIONS
LIGHT AND WARMER SWITCH – Turns on the heat to the bottom corn pan and heat light. KETTLE MOTOR SWITCH – Turns on the motor which drives kettle agitator shaft. KETTLE HEAT SWITCH – Turns on the heat element
AMOUNT OF POPCORN AND OIL
Your new Econo 8 is equipped with a corn measuring cup (Part No.47147). Corn charge – 8 oz. Oil charge – 2.4 oz. Flavacol – 1 1/2 teaspoon
POPPING INSTRUCTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
http://www.gmpopcorn.com Page 3
Econo 8 Model No. 2388, 2388EX
Light And Warmer Switch Part No. 42532 (2)
Kettle Motor Switch Part No. 42532 (2)
Kettle Heat Switch Part No. 42798 (1)
INSTALLATION AND OPERATING INSTRUCTIONS
CHECKING SHIPMENT
Unpack all cartons and check thoroughly for any damage which might have occurred in transit. Damage
claims should be filed immediately with the transportation company.
2388: 120V, 60Hz, 1525W 2388EX: 230V, 50Hz 1525W
If in doubt, your electrician must furnish sufficient power for proper machine operation. We recommend this popper be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
INSTALLATION
Your Econo 8 Popper was adjusted, inspected, and tested before it left the factory. Remove all packing before setting up your new Econo 8. Hang the kettle on the hanger assembly attached to the celling of your Econo 8. Finally, make sure to plug the power cord into the power receptacle located on the celling of your popper.
CONTROLS AND THEIR FUNCTIONS
LIGHT AND WARMER SWITCH – Turns on the heat to the bottom corn pan and heat light. KETTLE MOTOR SWITCH – Turns on the motor which drives kettle agitator shaft. KETTLE HEAT SWITCH – Turns on the heat element
AMOUNT OF POPCORN AND OIL
Your new Econo 8 is equipped with a corn measuring cup (Part No.47147). Corn charge – 8 oz. Oil charge – 2.4 oz. Flavacol – 1 1/2 teaspoon
POPPING INSTRUCTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
http://www.gmpopcorn.com Page 3
Econo 8 Model No. 2388, 2388EX
Light And Warmer Switch Part No. 42532 (2)
Kettle Motor Switch Part No. 42532 (2)
Kettle Heat Switch Part No. 42798 (1)
INSTALLATION AND OPERATING INSTRUCTIONS
CHECKING SHIPMENT
Unpack all cartons and check thoroughly for any damage which might have occurred in transit. Damage
claims should be filed immediately with the transportation company.
2388: 120V, 60Hz, 1525W 2388EX: 230V, 50Hz 1525W
If in doubt, your electrician must furnish sufficient power for proper machine operation. We recommend this popper be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal® Products Company’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance.
INSTALLATION
Your Econo 8 Popper was adjusted, inspected, and tested before it left the factory. Remove all packing before setting up your new Econo 8. Hang the kettle on the hanger assembly attached to the celling of your Econo 8. Finally, make sure to plug the power cord into the power receptacle located on the celling of your popper.
CONTROLS AND THEIR FUNCTIONS
LIGHT AND WARMER SWITCH – Turns on the heat to the bottom corn pan and heat light. KETTLE MOTOR SWITCH – Turns on the motor which drives kettle agitator shaft. KETTLE HEAT SWITCH – Turns on the heat element
AMOUNT OF POPCORN AND OIL
Your new Econo 8 is equipped with a corn measuring cup (Part No.47147). Corn charge – 8 oz. Oil charge – 2.4 oz. Flavacol – 1 1/2 teaspoon
POPPING INSTRUCTIONS
1. Turn Kettle Heat and Kettle Motor switch on.
2. Make a test pop by putting 3 kernels of corn and 1 oz. (30 ml) of oil into the kettle.
3. When the 3 kernels have popped, load the kettle with corn and oil charge.
4. When corn has popped, dump the kettle.
5. Repeat cycle starting with step number 3 above; always pop 3-5 batches for best popcorn.
http://www.gmpopcorn.com Page 3
Loading...
+ 7 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use