Gold Medal 2552-00-010, 2552-00-012 User Manual

0 (0)

Sun

Pop

Select

Sun Pop

Select

SunnyPop

Instruction Manual

and SunnyPopTM

Model No. 2552-00-010 and 2552-00-012

Model 2552-00-010

Model 2552-00-012

10700 Medallion Drive, Cincinnati, Ohio 45241-4807 USA

Part No. 110113

Sun Pop Select

DANGER

cause property damage, injury, or death. Any alterations to this equipment will

WARNING

and SunnyPop Model No. 2552-00-010 and 2552-00-012

SAFETY PRECAUTIONS

Machine must be properly grounded to prevent electrical shock to personnel. Failure to do so could result in serious injury, or death. DO NOT immerse any part of this equipment in water. DO NOT use excessive water when cleaning. Keep cord and plug off the ground and away from moisture. Always unplug the equipment before cleaning or servicing. Make sure all machine switches are in the OFF position before plugging the equipment into the receptacle.

Improper installation, adjustment, alteration, service, or maintenance can

void the warranty and may cause a dangerous condition. NEVER make alterations to this equipment. Read the Installation, Operating, and Maintenance Instructions thoroughly before installing, servicing, or operating this equipment.

008_051514

014_051514

To avoid burns, DO NOT touch the kettle or any heated surface. DO NOT place or leave objects in contact with heated surfaces.

013_092414

ALWAYS wear safety glasses when servicing this equipment.

010_010914

No user serviceable parts inside. Refer servicing to qualified service personnel.

011_051514

Read and understand operator’s manual and all other safety instructions before using this equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862

022_060215

Page 2

gmpopcorn.com

Sun Pop Select

WARNING

and SunnyPop Model No. 2552-00-010 and 2552-00-012

SAFETY PRECAUTIONS (continued)

DO NOT allow direct contact of this equipment by the public when used in food service locations. Only personnel trained and experienced in the equipment operation may operate this equipment. Carefully read all instructions before operation.

This machine is NOT to be operated by minors.

Note: Improvements are always being made to Gold Medal’s equipment. This

information may not be the latest available for your purposes. It is critical that you call Gold Medal’s Technical Service Department at 1-800-543-0862 for any questions about your machine operations, replacement parts, or any service questions. (Gold Medal Products Co. does not assume any liability for injury due to careless handling and/or reckless operation of this equipment.)

012_010914

007_010914

Page 3

gmpopcorn.com

Sun Pop Select

Aluminum

Measure

12 oz. Corn

Black Crutch Tips

Bulb for Cabinet

Knobs with Tee Bolt

Knob with Screw

Measure

and SunnyPop Model No. 2552-00-010 and 2552-00-012

INSTALLATION INSTRUCTIONS

Inspection of Shipment

After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be filed immediately with the transportation company. The warranty does not cover damage that occurs in transit, or damage caused by abuse, or consequential damage due to the operation of this machine, since it is beyond our control (reference warranty in back of manual).

Manual

Read and understand the operator’s manual and all other safety instructions before using this equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.

Model Description

Sun Pop Select Model:

2552-00-010: 12 oz. Popper with a Sun Pop Select LED lighted sign, and equipped with a

PowerOffTM Control feature.

SunnyPop Model:

2552-00-012: 12 oz. Popper with a SunnyPop LED lighted sign, and equipped with a

PowerOffTM Control feature.

Items Included with this Unit

Scoop

14.7 cc

1/2 Cup

Measure

Interior

(for Popper Doors)

(for Old Maid Pan)

Page 4

gmpopcorn.com

Sun Pop Select

Black Crutch Tip

Glide

(pre-installed

General image shown for reference.

and SunnyPop Model No. 2552-00-010 and 2552-00-012

Setup

This unit has been tested at the factory.

1. Remove all packaging and tape prior to operation.

2. Place the unit on a sturdy, level base.

3. The Popper must be installed with a minimum 6” clearance

4. The popper unit has 4 glide feet preinstalled at the factory (reference image shown).

Install a Black Crutch Tip on each of the 4 glide feet. Firmly push the crutch tip over the glide until it covers the glide entirely.

5. Door knobs are shipped in the accessories pack located inside the machine. Install a

door knob with tee bolt on each popper door (insert tee bolt from interior side of door, then fasten knob on exterior side).

6. Install the knob with screw on the old maid pan.

7. Carefully install the light bulb (do not over-tighten) into the lamp holder located in the

cabinet interior. Ensure the unit is OFF and unplugged before installing or changing the bulb (reference the Electrical Requirements section).

at the factory)

Page 5

gmpopcorn.com

Sun Pop Select

DANGER

CAUTION

and SunnyPop Model No. 2552-00-010 and 2552-00-012

Electrical Requirements

The following power supply must be provided:

2552-00-010, 2552-00-012: 120 V~, 1400 W, 60 Hz

A certified electrician must furnish sufficient power for proper machine operation and install any supplied receptacle. We recommend this equipment be on a dedicated and protected circuit. Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold Medal Products Co.’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance. Make sure cord is located to prevent a trip hazard or unit upset.

008_051514

Before You Plug In Machine

1. Make sure all machine switches are in the OFF position before plugging the equipment

into the receptacle.

2. Make sure the wall outlet can accept the grounded plugs (where applicable) on the

power supply cord.

3. The wall outlet must have the proper polarity. If in doubt, have a competent

electrician inspect the outlet and correct if necessary.

4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).

5. Install the unit in a level position.

If the supply cord is damaged, it must be replaced by Gold Medal Products Co., its service agent or similarly qualified persons in order to avoid a hazard.

039_080614

Page 6

gmpopcorn.com

Sun Pop Select

Kettle Motor Switch

Label used on units with the

Lights/Warmer

and SunnyPop Model No. 2552-00-010 and 2552-00-012

OPERATING INSTRUCTIONS

Controls and Their Functions

KETTLE HEAT SWITCH

Two position, ON/OFF lighted rocker switch - supplies power to the heating elements in the popping kettle. The green switch light ON indicates there is power to the kettle heating element.

KETTLE MOTOR SWITCH

Two position, ON/OFF lighted rocker switch - supplies power to the kettle agitator motor. The Kettle Motor Switch MUST be ON at all times when there is popcorn (popped or unpopped) in the kettle. The green switch light ON indicates there is power to the agitator motor.

LIGHTS/WARMER SWITCH

Two position, ON/OFF lighted rocker switch - supplies power to the popcorn sign, interior cabinet light, and heat element for the corn pan.

PowerOff Control feature.

Kettle Heat Switch

Switch

POWEROFF CONTROL

The PowerOff Control feature will automatically turn the kettle heat off after 15 minutes of idle time (no popcorn popped). The PowerOff Control will prevent the heat element and thermostat from cycling OFF-ON if the Kettle Heat Switch is left on. This feature saves electrical power and extends the life of the kettle heating element and thermostat.

• When the Kettle Heat Switch is turned ON, and the kettle thermostat switches OFF,

the PowerOff Control’s 15 minute timer starts; the 15 minute timer resets each time a batch of popcorn is popped.

• The small green neon light in the Kettle Heat Switch will blink OFF-ON to indicate

the kettle has been automatically turned OFF.

• To restart the kettle heating, cycle the Kettle Heat Switch OFF-ON.

Page 7

gmpopcorn.com

Sun Pop Select

Kettle

Size

Popcorn

Charge

Oil

Charge

Flavacol (Salt)

12 oz.

12 oz. (355 ml)

4 oz. (

118 ml) 1

Tblsp. (

cc)

and SunnyPop Model No. 2552-00-010 and 2552-00-012

Popping Corn

This section describes instructions for popping Standard (salted popcorn).

Amount of Popcorn and Oil

Your new popper is equipped with a corn, salt, and oil measure. We recommend flavored and colored coconut oil. Popcorn popped in coconut oil stays fresh longer and does not leave black deposits in your kettle like other oils. Use only top quality, fresh popcorn from reputable suppliers.

Ingredient amounts for popping Standard Popcorn:

For best results use Mega-Pop® 12 oz. premeasured pouches (Item# 2839).

Popping Standard (Salted) Popcorn

1. Turn the Lights/Warmer, Kettle Heat and Kettle Motor Switches ON.

2. To determine when the kettle is ready to pop corn (about 4 minutes), test pop three

kernels of corn and one ounce (30 ml) of popping oil. When the kernels pop, the kettle is ready for use.

3. Lift the kettle lid and load the Mega-Pop® premeasured popcorn and oil pouch into

kettle, or pour in the popcorn and Flavacol, then add oil in the premeasured amounts specified above. Close lid.

4. When the corn has finished popping, gently dump the popcorn.

5. On the final kettle of corn, turn the Kettle Heat Switch OFF just as the lids are forced

open by the popping corn. This procedure saves electricity, since the kettle has plenty of heat, and helps eliminate smoke/odor from any oil residue that remains after popping has stopped.

6. When finished popping, make sure KETTLE HEAT and KETTLE MOTOR switches are

turned OFF.

NEVER LEAVE THE HEAT ON WHEN YOU ARE NOT POPPING CORN!

If Auto Shut-OFF is enabled, unit will automatically shut kettle heat OFF after 15 minutes of idle time (no popcorn popped). To restart kettle heating, cycle the Heat Switch OFF-ON.

Page 8

gmpopcorn.com

Sun Pop Select

DANGER

WARNING

and SunnyPop Model No. 2552-00-010 and 2552-00-012

Care and Cleaning

Machine must be properly grounded to prevent electrical shock to personnel.

DO NOT immerse in water.

Always unplug the equipment before cleaning or servicing.

To avoid serious burns, DO NOT touch the kettle while it is hot!

Good sanitation practice demands that all food preparation equipment be cleaned regularly (only use non-toxic, food grade cleaners). A clean looking, well-kept machine is one of the best ways of advertising your product.

025_020314

028_082715

Note: It is extremely important to follow all of the cleaning procedures, otherwise parts

damage and equipment failure will result. The warranty does not cover parts that are damaged due to improper cleaning.

Daily Kettle Cleaning Instructions

CAUTION: A hot kettle will cause burns if you touch it with your hand. Allow kettle to cool

at least 1 hour before attempting to clean. DO NOT use ice or water to cool down a hot kettle! Severe kettle damage will result!

1. When cool, wipe the outside of the kettle with a clean, soft cloth. DO NOT use oven

cleaners or abrasive materials as they will damage the kettle.

2. Every night, mix Gold Medal’s Heat’n Kleen solution (Item No. 2095), 2 tablespoons

per gallon of water. It is not necessary to use the entire gallon at once; only use enough to fill the kettle 1/2 inch deep.

3. Turn the kettle heat ON. When the water starts to boil, turn the kettle heat OFF.

4. Allow to cool for at least 1 hour, then dump the solution into a bucket and wipe the

inside of the kettle with a clean cloth. Make sure all of the solution goes into the bucket; do not spill any in the interior of the machine.

For extra dirty kettles, the process may be repeated; or, after turning the kettle heat OFF, allow solution to sit in the kettle overnight. The next morning, dump the solution into a bucket and wipe the inside of the kettle with a clean cloth.

5. With the unit OFF and unplugged, wipe the kettle lead cord with a clean SLIGHTLY damp

cloth. DO NOT get moisture into the kettle lead-in cord, severe damage will result.

Page 9

gmpopcorn.com

+ 20 hidden pages