Gold medal 2552, 2552KC, 2552LS User Manual [ru]
Part No. 49749
Pop Maxx
Instruction Manual
Models: 2552, 2552KC, and 2552LS
SAFETY PRECAUTIONS
Pop Maxx
Forward
This manual covers the 12/14 oz. Pop Maxx Popcorn Machine, model number 2552, 2552LS, 2552KC.
Installation Instructions
Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during transit.
Damage claims should be filed immediately with the transportation company. Gold Medal is not
responsible for damage that occurs in transit.
Setup:
Your new Pop Maxx Popcorn Machine is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.
Electrical Requirements:
The following power supply must be provided:
Model No. 2552: 120 VAC, 60 Hz. 1440 Watts 12 Amps
Model No. 2552LS: 120 VAC, 60 Hz. 1480 Watts 12.3 Amps
Model No. 2552KC: 120 VAC, 60 Hz. 1440 Watts 12 Amps
.
Your electrician must furnish sufficient current for proper machine operation. We recommend this
popper be on a dedicated and circuit protected line. Failure to wire properly will void the warranty
and can result in damage to the heat elements, light, motor and etc.
It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a
wall outlet. The use of extension cords is not recommended due to safety reasons and the popper’s
performance will be sacrificed/reduced.
Before You Plug In Machine:
1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power supply
cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the
outlet and correct if necessary.
3. DO NOT use a three (3) prong grounded to two (2) prong un-grounded adapter.
3
Models #2552, #2552LS, #2552KC,
Operating Instructions
Controls and Their Functions
Light & Warmer Switch
This switch operates the overhead light and corn deck freshener heat element.
Kettle Motor Switch
This switch operates the popcorn agitator shaft. This switch must be ON at all times when
popcorn (popped and un-popped) is present in the kettle.
Kettle Heat Switch
This switch turns on the heat element located in the popcorn kettle.
Kettle Heat
Switch
p/n 42798
Kettle Motor
Switch
p/n 42532
Pop Maxx
Lights/Warmer
Switch
p/n 42532
4
Models #2552, #2552LS, #2552KC,
Pop Maxx
Amount of Popcorn and Oil:
Your new popper is equipped with a corn, salt, and oil measure. We recommend flavored and
colored coconut oil. Popcorn popped in coconut oil stays fresh longer and does not leave black
deposits in your kettle like other oils. Use only top quality fresh hybrid popcorn from reputable
suppliers.
Corn charge – 12 oz./14 oz.
Oil charge – 3.5 oz./4.2 oz.
Flavacol – 14.7 cc (measure included with accessory kit)
*for best results use mega-pop premeasured pouches (item # 2839)
Popping Instructions:
1. Turn both the KETTLE HEAT and KETTLE STIR MOTOR switches ON.
2. Test pop three (3) kernels of corn and one ounce (1 Oz.) of popping oil. When the kernels pop,
the kettle is ready for use.
3. Load both a full corn/oil charge and Flavacol Seasoning Salt into the kettle. Close the lids.
4. When the corn has finished popping, gently dump the kettle.
5. Repeat the cycle, starting with step number 3, until the desired amount of popcorn has been
achieved. Always pop 3 to 5 consecutive batches for the best popcorn.
On the final kettle of corn, it is a good idea to turn the KETTLE HEAT switch OFF just as the lids are
forced open by the popping corn. This procedure saves electricity since the kettle has plenty of heat
and eliminates smoke/odor from any oil residue that remains after you have stopped popping.
Pappy’s Kettle Corn Instructions
1. Turn kettle heat, stir motor, and lights to the ON position
2. First Batch Online: pre-heat kettle for 4 minutes.
3. Add 3/8 part oil and 1 part popcorn into the kettle (No Salt!). Start timer for 45-60 seconds.
4. Add 2/3 part Pappy’s into kettle when timer goes off. If popping has just started, close the right
door and carefully/quickly add the Pappy’s mix through the left door. Re-open right door.
5. Dump Kettle when popping has nearly stopped, repeat steps 3 and 4. Salt and mix the popped
corn thoroughly. Pop at least 5 batches.
5
Models #2552, #2552LS, #2552KC,
Count Down timer Instructions
1. Press MIN and SEC together to reset timer to zeo.
2. Use MIN and SEC buttons to set time.
3. Press START button to start or stop.
4. The alarm will sound for 60 seconds or press any key to stop alarm. The timer will return to the
set time.
5. Timer part number - 63012
Pop Maxx
6
Models #2552, #2552LS, #2552KC,
Loading...