Gold Medal 2396AC Installation Manual

Part No. 39481

a

Revised March 2005

Bag-In-A-Box

Single/Dual Pedestal

Enclosed Butter Dispenser

Instruction Manual

Model #2396AC and #2396ADC

del #2396ACR and #2396ADCR

Mo

SAFETY PRECAUTIONS

a

Bag-In-A-Box Enclosed Butter Dispenser

a

CHECKING SHIPMENT

Your new Bag-In-A-Box Enclosed Butter Dispenser is ready for installation in your counter. Remove the
machine from the corrugated carton. Check thoroughly for any damage, which may have occurred in transit.
Damage claims should be filed immediately with the transportation company.

ELECTRICAL REQUIREMENTS

Model No. 2396AC, 2396ACR – 120 Volts, 2.5 Amps, 300 Watts, 60 Hz

del No. 2396ADC, 2396ADCR – 120 Volts, 2.9 Amps, 348 Watts, 60 Hz

Mo

INSTALLATION INSTRUCTIONS

1. The bottom portion of the enclosed butter dispenser rolls to an area under the counter where the
pedestal is to be mounted. Access will be required to the front of this area allowing sufficient clearance
to clean and maintain the pump and add or remove boxes of topping.

2. The countertop will require preparation by drilling the mounting holes and by cutting the rectangular
holes for the power cable, the tube, the drip pan and remote switch. If your counter is thicker than the
provided mounting studs attached to the pedestal, then counter bore the underside of the counter top to
allow for the wing nuts.

3. Set the pedestal onto the counter top and secure it in place with the wing nuts.

4. Attach the heated-line tubing from the base to the aluminum tube on the pedestal with the hose clamp
provided.

5. Plug the six-prong power cable from the pedestal into the side of the control box on top of the rack
assembly.

6. Plug the power cord from the rack assembly into a proper outlet.

7. If this is a dual pedestal unit, turn the power on and test the connections. Press the dispense button and
check to see that the correct pump is running to feed product to that pedestal. If not, turn the power off
and simply switch the six-prong plugs to the opposite receptacle.

8. Load two boxes of pre-heated topping into the rack. Gold Medal’s Backroom Warmer, Item #2262, may
be purchased for pre-heating the topping. Remove the cardboard cutout on the box to expose the
quick-disconnect fitting.

9. Attach the quick-disconnect fittings on the end of the tubing, to the fittings on the box of topping. The
end fitting should attach to the upper box and the middle fitting should attach to the lower box.

10. The unit is now ready for use.

INSTALLATION

All Models #2396AC, #2396ADC

3

Bag-In-A-Box Enclosed Butter Dispenser

a

OPERATING INSTRUCTIONS

1. Turn the master power switch, located on the front of the control box, to the PUMP & HEAT position.
This will start the heater/blower that will maintain cabinet temperature, activate the foil heater in the
pedestal, and provide power for the pump.

2. Pressing and holding either of the red buttons located on the pedestal will dispense topping. If this is
the first time the unit has been used, it may take a minute to completely fill the tube and dispense
topping.

3. Turn the master power switch, located on the front of the control box, to the HEAT ONLY position. This
will start the heater/blower that will maintain cabinet temperature and activate the foil heater in the
pedestal only. The pump is de-activated.

CLEANING INSTRUCTIONS

SANITIZING INSTRUCTIONS

Your Model 2396AC and 2396ADC is all stainless steel construction. The exterior surfaces can be cleaned

wiping oil spills with a dry towel, then wiping with another towel moistened with mild soap and warm

by
water.

Sanitizing the internal parts; tubing, pump, etc.

1. Disengage the bag connector from the bag of oil and place in a pail of hot water and mild soap.
Approximately 1 gallon.

2. Push the dispense button to flush the system of oil. Make sure you have a container under the
discharge tube. Discard the oil.

3. Put the intake line in the hot water and pump it through the lines by holding the dispense button until the
pail is empty.

4. Fill the pail with a sanitizing solution. Gold Medal offers a product for this purpose, Chlor-Tech, part
number 1109. Put the bag connector in the pail of sanitizer. Pump it through the lines by holding the
dispense button until the pail is empty. It is not necessary to flush the sanitizer before the next step, but
you may flush with water if desired.

5. Before the next use, install the connector to a bag of oil and pump oil until oil is dispensed through the
discharge tube.

hedule for Cleaning

Sc

The recommended sanitizing schedule is every night.

IMPORTANT:

This product is not intended for use with volatile food products, i.e. real butter.

All Models #2396AC, #2396ADC

4