GN Audio USA HHB600 UserMan rev Agreement

FCC Notice to Users

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any interference received,

including interference that may cause undesired operation.

Users are not permitted to make changes or modify the device in any way. Changes or modifications not
expressly approved by Siemens will void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna must not be co-located or operating in conjunction with any other antenna or
transmitter.

IC Notice to Users

Operation is subject to the following two conditions:
(1) This device may not cause interference and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.

The term "IC:" before the certification/registration number only signifies that registration was performed
based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It
does not imply that industry Canada approved the equipment

- 2 -