Global Industrial 246719 User Manual
Patio Heater, Wall Mount,
Infrared Black Panel
User Manual
Model 246719
Read this manual thoroughly prior to installation and operation.
Keep these instructions in a safe location for future reference.
For questions, visit globalindustrial.com or contact Customer Service at 1-800-645-2986.
SAFETY INFORMATION
TO REDUCE RISK OF FIRE, ELECTRIC SHOCK, INJURY OR DAMAGE, READ AND FOLLOW ALL
SAFETY PRECAUTIONS, OTHERWISE WARRANTY WILL BE VOIDED.
WARNING: To prevent overheating, keep the air inlets and outlets clean and free of anything that may
cause blockage. Often check all inlets and outlets to ensure they are clear of any dirt or dust
accumulation. DO NOT COVER.
WARNING: Parts of the heater may exceed 390ºF, contact with the heating tube, reflector, or mental
parts near the heating tube, may cause severe BURNS. DO NOT let bare skin touch hot surfaces. Switch
off, unplug and allow the heater to completely cool off before making contact.
WARNING: If provided, use handles when moving this heater. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet from the front of the heater and
keep them away from the sides and rear.
DO NOT insert fingers or objects into any of the openings.
DO NOT use this heater in the immediate surroundings of water (bath, shower, swimming pool, etc.).
DO NOT touch this heater of its controls with wet hands.
Keep all objects a minimum of 3-ft. away from the heater.
DO NOT cover the heater, or put objects such as fabrics or combustible materials in contact with the heater.
DO NOT allow children to play with the appliance. Keep children away unless continuously supervised.
Ensure supply voltage does not exceed 245 volts.
The use of these heaters is forbidden in any area where there is a presence of gases, explosives or
inflammable objects.
Neither the connecting cable nor any other object must come into contact with the heater.
This heater should be switched off at the isolating switch before maintenance or repair work.
Installation and repairs must be carried out by a qualified installer in accordance with current local electrical
regulations.
The heater must not be installed just below an electrical socket-outlet.
Never touch the heater with wet or humid hands or while barefoot.
DO NOT expose to direct rain/snowfall.
The supply circuit must incorporate a double-pole isolating switch having a contact separation of at least
1/8”.
DO NOT operate if the power cord or plug is damaged, after a malfunction, or after the unit has been
dropped or damaged in any manner. Disconnect power and have the heater inspected by a reputable
electrician before reusing.
Connect to properly grounded outlets only.
It is important to maintain a minimum distance of 3-feet between the heater and curtains, or any other
Model:
246719
Voltage:
208-240V
Wattage:
2000-2600W
Construction
Structured Aluminum
Application:
Outdoor
Current:
11A
Frequency:
60Hz
Warm-up Time:
< 10 Minutes
Features:
Medium and High Power Levels
0-24 Hour Timer (1 hour increments)
Wavelength Length:
3 - 10μm
Protection:
IP65
Warranty
2 Years
Certification:
ETL
Dimensions:
59”L x 6-3/8”W x 1-3/4”H
Weight:
19 lbs.
Cord Length:
6 ft.
combustible materials that will be affected by the radiated heat.
DO NOT touch the fireguard or reflecting cover when the heater is in use; do not insert any objects into the
fireguard to prevent high temperature scalding.
Heater for outdoor use only.
Outdoor weatherproof outlet is recommended.
NEVER leave the heater unattended while it is operating.
DO NOT run cord under carpeting, throw rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from high traffic areas and where it will not be tripped over.
DO NOT let the power cable hang over the edge of a table/counter or let it come in contact with hot surfaces.
DO NOT use an extension cord.
To disconnect heater, turn controls to off, then remove plug from outlet.
Disconnect heater during installation and maintenance.
NEVER place hands under the heating elements. ALWAYS allow heating element to cool at least 10 minutes
before touching the heating tube or adjacent parts.
The heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
NEVER dismantle the components of the heater or replace with components not offered or recommended by
Global Industrial.
SPECIFICATIONS:
This heater is rated to be mounted outdoors, but must be installed where it will be sheltered from the
effects of weather. DO NOT expose to direct rain or snowfall
.
Loading...