Giant CITY SPEED V1.0 User Manual

How to replace the batte

AA SIZE)

with a new one.

Warranty

Handlebar alignment:

ugh so that you

Rear light on

the

rear carrier

9.8-1

1.7

Nm (87-

103

In. lbs.)

with a new one

CITY SPEED USER GUIDE VERSION 1.0

Congratulations on your purchase of a GIANT CITY SPEED. GIANT CITY SPEED represents the latest in design and engineering, and also requires special care. While Giant Bicycle engineers have used the best quality, most durable and lowest maintenance materials for this CITY SPEED, you must follow certain guidelines to attain optimal performance and proper wear characteristics.

WARNING

void your warranty, and may result in hidden damage to

the CITY SPEED. Damage to the CITY SPEED can cause

loss of structural integrity, which may result in serious personal injury.

Rear light

Front light

Step 1

Step 2

Step 3

sure to install the battery as shown in the diagram.

Failure to follow these Instructions will

Rear light

Fixing bolt

Battery holder

CAUTION

The battery has polarity (+/- sides), so be

Loosen the battery holder

fixing bolt with 2.5mm Allen Key

Take out the battery holder from the stem

Replace the battery (

Front light

Rear light

How to replace the battery

Step 1

Step 2

WARNING

applicable due to the integrated design of seat clamp.

Step 1

Step 2

CAUTION

sure to install the battery with the + side upward as

shown in the diagram.

Full composite seat post is NOT

Replace the battery (CR2032) with a new one

The battery has polarity (+/- sides), so be

Loosen the battery holder fixing bolt with 2.5mm Allen key

Tightening torque:

Replace the battery (CR2032)

Loosen the battery holder fixing bolt with 2.5mm Allen key

Handlebar

Step 1

Tightening torque: 11.7-14.7 Nm (104-130 In. lbs.)

CAUTION

binder bolt may compromise steering action, which could cause you to lose

front wheel of the bicycle between your legs and attempt to twist the handlebar/stem assembly. If you can twist the stem in relation to the front wheel, the bolts are insufficiently tightened.

Please refer to the Giant Owner’s Manual for complete provisions of the warranty.

An insufficiently tightened handlebar

Loosen the handlebar binder bolt with 6mm Allen key to make sure the handlebar stem is parallel to the bike’s center line and clamped tight eno can’t twist it out of alignment

control and fall. Place the

www.giant-bicycles.com