Genius Wireless TwinTouch Optical Office User Manual
Hardware Installation
1. You can connect the receiver to a USB port of a PC.
2. Install two AA rechargeable batteries in the mouse and two AA rechargeable
batteries in the keyboard.
3. Turn on your computer.
4. The channel buttons are factory preset. If your keyboard/mouse does not work,
then follow the next step.
5. After you open Windows, to set the ID channel setting, please press the button
on the receiver first (RB) and press the button under the mouse (MB) within six
seconds. Now press the receiver button again and the button under the keyboard
(KB) within six seconds. So you press RB, MB, then the RB, KB to set the channel setting.
Important: You can use the battery charger receiver to recharge two AA or two
AAA rechargeable batteries each time when you use the PC. Plug the battery
charger receiver USB connector into the PC directly and remember do not put the
batteries in the wrong direction, use the same types of batteries, and do not
recharge via the USB hub, that will make your receiver, main-board and hub burn
or become non-usable easily. Also, keep all drinks away! If any spill occurs on the
receiver, unplug the USB connector first and clean the receiver immediately. Please
remove the batteries if you do not use this device for at least two weeks.
Warning: (Troubleshooting)
1. Please do not use Wireless TwinTouch Optical Office on a desk which is made
of glass, mirror, iron, or black velvet. Also, a flat surface is necessary or the Op
tical Sensor will error easily. When you use Wireless TwinTouch Optical Office
on a desk that is made of metal, try using a pad or reduce the receiving distance.
2. Before the first installation is completed (channel setting ready), the keyboard
will not work in DOS. If your USB keyboard does not work in BIOS, DOS or
Windows, then use another PS2 keyboard to make the USB controller (USB
function) and USB legacy (USB keyboard) “On” in the BIOS setup. This may
occur with older BIOS versions. Then unplug the PS/2 keyboard and plug in
your USB keyboard and everything should be working properly.
3. The Wireless TwinTouch Optical Office channel provides 256 ID-codes, and it
automatically selects the ID # for your keyboard and mouse. You can only set up
one Wireless TwinTouch Optical Office at a time. But if you have additional
ENGLISH
-
1
Wireless TwinTouch Optical Office sets in an area of 10 square meters, more
interference may occur between the receiver and your keyboard and mouse.
4. If you feel the mouse does not move smooth as usual or the keyboard does not
work when typing, then the batteries have lost their charge, so please replace
them. Also, the wireless icon will be blinking “red” when there is a battery-low
situation. The LED on the receiver shows the battery-recharging status (from
shining to LED completely “on” for battery full). You should set up the channel
every time you replace the batterires.
5. If you need to buy new batteries, please choose Ni-MH (Nickel-Metal-Hydride)
AA batteries, 1.2V, 1300 to 1600 mAH. Please do not mix or use other types
of batteries (Li-ion, Ni-Cd, Alkaline, etc.).
6. The Wireless TwinTouch Optical Office with radio frequency gives you free
movement and an enjoyable experience. For optimal performance, place the receiver at least 8 inches (about 20 cm) away from the mouse and other electrical
devices, such as the computer, monitor, and etc.
Software Installation
1. Make sure the mouse and keyboard is connected to the computer.
2. Put the Setup disk (or CD) into the disk drive.
3. Follow the instructions on the screen to finish the software installation.
Factory Setting
1. Mouse:
Button Assignments
The Button Assignment feature lets you work in a more efficient way because you
can assign the most frequently used commands in Windows to the mouse buttons.
Magic-Roller Press the “Magic-Roller” to surf the Internet and Windows docu
-
ments
2
Left Button Provides traditional mouse functions such as click, double click and
drag.
Right Button You can assign this button frequently used keyboard and mouse func
tions in addition to features like EasyJump, Auto-Panning, Zoom, etc.
Roller ButtonYou can assign this button frequently used keyboard and mouse func
tions in addition to features like EasyJump, Auto-Panning, Zoom, etc.
Side Buttons You can assign certain functions (Application/Document, Horizontal
Scroll, Last/Next Page, and Zoom in/out) to the upper or lower side
button with the roller.
2. Keyboard:
1. Word: Open Word application
2. Excel: Open Excel application
3. Scroll Wheel: For fast browsing and switching
between applications. (If you want to select the
application, please switch the scroll wheel
again.)
4. Vol.-& +: decrease or increase volume
5. Mute: Remove the sound
6. Play & Pause: Play and pause of audio or video
CD’s
7. Rewind: Previous track of audio or video CD’s
8. Forward: Next track of audio or video CD’s
9. Stop: Stop play of audio or video CD’s
10. Media: Controls the playback of music CDs and
PC audio
11. E-mail: Open mail folder
12. Stop: Stop your command when using the browser
13. Refresh: Refresh the page
14. Back: See last page when viewing the Internet
15. www: Open browser in Netscape or IE
16. Forward: Go to next page when viewing the Internet
17. Search: Open the search function when you using browser
18. My favorite: Open my favorite web-site
19. Sleep: Turn system into sleep mode
20. Calculator: Open the calculator from Windows
21. My Computer: Open my computer folder from Windows
MouseMate Software Features
Browsing Speed You can adjust the browsing speed when you surf the
Browsing
Direction
Internet or Windows documents.
Move the “Magic-Roller” forward and the screen will
browse to the top of the document. Move it in reverse and
the document will go in the opposite direction
-
-
ENGLISH
3
Loading...