Genius Navigator 900G, GM-060038 Installation Manual

ENGLISH

1

Navigator 900G Laser (GM-060038)

Hardware Installation

1. You can connect the receiver to a USB port of a PC

2. Install two AAA batteries in the mouse.

3. Turn on your computer. The mouse can be worked.
Note: If the mouse does not have connection to the receiver, press the button on
the receiver first and then press the button under the mouse for channel setting
again.

Important: Remember do not put the batteries in the wrong direction; use the
same types of batteries. Also, keep all drinks away! If any spill occurs on the
receiver, unplug the USB connector first and clean the receiver immediately.
Please switch the button to "off" under the mouse once you don't use it for a
long time, and remove the batteries if you do not use this device for at least two

ENGLISH

2

weeks.
W

arning: (Troubleshooting)

1. Please do not use wireless laser mouse on a desk, which is made of glass or
mirror. Also, a flat surface is necessary or the laser sensor will error easily.
When you use wireless laser mouse on a desk that is made of metal, try
using a pad and reduce the receiving distance.

2. The wireless laser mouse channel provides 16 channels and 256 ID-codes,
and it automatically selects the ID # for your mouse. You can only set up
one wireless laser mouse at a time.

3. If the power indicator

is on (see Button Assignments), then the

batteries have lost their charge, so you need to replace them.

This device complies with Part 15 of the FCC rules, operation is subject to the
following two conditions.

（1）

This device may not cause harmful interference and,

（2）

This device must accept any interference received,

including interference that may cause undesired operation .

NOTE:

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT

Software Installation

1. Make sure the mouse is connected to the computer.

2. Put the CD driver into the CD drive.

3. Follow the instructions on the screen to finish the software installation.

Security Function Setting:

1. After you install software driver, please click the mouse icon on the task bar