Genius DVR player User Manual

English

1

WEEE Warning Message

Symbol for Separate Collection in European Countries

This symbol indicates that this product is to be collected separately.
The following apply only to users in European countries:

z This product is designated for separate collection at an appropriate collection p oint. Do not dispose of as household waste.
z For more information, contact the retailer or the local authorities in charge of waste management.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Opera tion is sub ject to the following two conditions:

(1). This device may not cause harmful interference, and
(2). This device must accept any interference received, including interference that may ca use undesired operation.

Note:

This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant t o Part 15 of the FCC rules. These limits are designed
to provide reasonable protection a gainst harmful interference in a reside ntial installation. This equipment gene rates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:

 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be ma de, you
could be required to stop operation of the equipment.

English

2

Software introduction

This DVR Player provides seamless DVR recordings for use with a PC application program (AP).
You do not need to install any program and you can quickly browse, playback or convert the
recorded video. Here are some of the features:

¾ Green Software: Do not need to install, but can be based on the language version of windows. It

will automatically display the language.

¾ Basic functions: Provides video of browsing, playback, speed switch and dump into AVI video or

JPG photo of the function.

¾ Password protected: You can set a password for the SD card to protect the SD card contents

from others.

¾ Video Repair: Can repair damaged video because of a suddenly pulled out card or power outage.

This can ensure that critical evidence is not lost.

How to use the Genius DVR Player

System Requirements

• CPU: At least Pentium 4 2.4GHz or above

• Monitor: Required to support 1280 x 720 or 1280 x 1024 resolution of the screen

• RAM: At least 1 GB of memory

• OS: Supports Windows XP, Windows Vista (32/64bit), and Windows 7 (32/64bit)

• Audio: System must have audio device installed

• USB 2.0 High Speed support of SD / SDHC card reader

Software Installation

• You do not need to install, you can execute the program directly, and the program can be

executed in the SD card (SD card cannot be write-protected).

• In Windows Vista and Windows 7, the exec. shall be the system administrator to open the normal

execution.

English

3

Software Interface Description

Image display area: Displays the current playback image.

➊

Playback progress bar: Shows the progress of video playback, drag the mouse and you can

playback the video position where you want.

➋

Video section list: Displays the current SD card list of all videos.

Videos in sections (Clip): Each section has a time listed when it started recording video
segments. The SD card will list all the video segments. You can choose the video you want to
view.

➌

Video Groups List: The SD card shows the current group information list of all the videos.

A continuous video group can be shown in video segments. Any video longs than two seconds
is considered another group.
General continuous-time recording of the section will be treated as the same group, but there
are two circumstances would be regarded as another group:

NOTE

1. Each group will consist of video clips till the memory is full to 125MB.

2. Press the Lock button to protect the video and display in a group.

3. If you pull out the CD card or there is no power, or the battery does not work properly, the videos
damaged in the group will show and display in a red background. Damaged groups cannot be
played back for conversion without the use of "Repair "function. For "Repair Video" function, refer
to the button instructions.

English

4

Buttons instructions

Open Disk:

Open the video with SD card drive

Open SD card Disk, G:\ disk, choose G:\ and press “apply” button.

If the SD card has a password, enter the correct password to open the SD card to view the video.

If the disk and password are correct and SD card has the recorded image, the software interface
will start playback of the section of the image.

Snapshot button:

Save the current screen captured into a JPG image file.

During playback or pause playback of the video, you can press this button to save as a JPG image
file, the file name will be saved as the screen name at the time.

Video archive button:

The recorded video image will be transferred as AVI video.

1. If you want to store in a single group or within a certain segment of the video, you can directly

select the group list in the film. Press the button video archive. After the selection, the path you
want to archive will appear, then you can choose to back up to check the video section, or choose
to save the entire group all of the backup videos.
On the bottom right, there is a file estimate, so you can see how much storage has been used.