The content in this document is for information purpose and is subject to change without
prior notice. We made every effort to ensure that this User Guide is accurate and complete.
However, no liability is assumed for any errors and omissions that may have occurred.
The manufacturer reserves the right to change the technical specifications without prior
notice.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
WEEE Notice
Disposal of Waste Electrical and Electronic Equipment and/or Battery by users in
private households in the European Union
This symbol on the product or on the packaging indicates that this can not be
disposed of as a household waste. You must dispose of your waste equipment
and/or battery by handling it over to the applicable take-back scheme for the
recycling of electrical and electronic equipment and/or battery. For more
information about recycling of this equipment and/or battery, please contact
your city office, the shop where you purchased the equipment or your
household waste disposal service. The recycling of materials will help to
conserve natural resources and ensure that it is recycled in a manner that
protects human health and environment.
CE Regulatory Notice
This equipment complies with the requirements set out in the Council Directives on the
Approximation of the Laws of the Member States relating Electromagnetic Compatibility
(2004/108/EC); the Low Voltage Directive (2006/95/EC); the Restriction of The Use of
Certain Hazardous Substances in Electrical And Electronic Equipment Directive
(2002/95/EC), Turkish EEE Directive; the Commission Regulation (EC) No 1275/2008
implementing Directive 2005/32/EC of the European Parliament and of the Council with
regard to eco-design requirements for standby and off mode electric power consumption of
electrical and electronic household and office equipment, and the Directive 2009/125/EC of
the European parliament and of the council establishing a framework for the setting of
eco-design requirements for energy-related products.
Notes on Installation
1.
Install the device near the rear-view mirror to obtain the best
open-field view.
2.
Make sure that the lens is within the wiping range of the windscreen
wiper to ensure a clear view even when it rains.
3.
Do not touch the lens with your fingers. Finger grease may be left
on the lens and will result in unclear videos or snapshots. Clean the
lens on a regular basis.
4.
Do not install the device on a tinted window. Doing so may damage
the tint film.
5.
Make sure that the installation position is not hindered by the tinted
window.
MODEL: SP5
Li-Polymer 3.7V 470mAh 1.7Wh
Be sure to use only the supplied battery and charger. The use of any
other type of battery or charger may damage the device and void your
warranty.
Caution
Use the authorized charger only.
Never disassemble by yourself.
Never short-circuit the battery.
Dispose of the battery properly.
Exposing the battery to open flames can cause explosion.
WANSGLORY CO., LTD.
5
6
1 Introduction
Thank you for purchasing this advanced Car Recorder. This device
is specifically designed for real time video and audio recording
when driving.
1.1 Features
• Full HD camera (1920x1080 @ 30fps)
• 2.4” LCD color screen
• Wide angle lens
• High power LED for low light environments
• Motion detection
• Automatic Emergency recording for collision detection
• Supports Micro SDHC up to 32GB
1.2 Package Contents
The package contains the following items. In case there is any
missing or damaged item, contact your dealer immediately.
To operate the device, press the corresponding buttons (9, 11, 12, 13) according to
Note:
guide icons shown the screen.
Item
No.
9 Back Button ( )
10 LCD Panel
11 Up Button ( )
12 Down Button ( )
13 Enter Button ()
14 Wide Angle Lens
15 Speaker
16 LED Light
13
16
Item
2 Getting Started
2.1 Inserting the Memory Card
Insert the memory card with the gold contacts facing the back of the
device. Push the memory card until it clicks into place.
To remove the memory card
Push to eject the memory card out of the slot.
Do not remove or insert the memory card when the device is turned on. This may
Note:
damage the memory card.
8
2.2 Installing in Vehicles
2.2.1 Mount to Windshield
1. Press and hold the
PUSH button and pull to
detach the bracket base.
2. Attach the device to the
bracket base. Turn and
tighten the car holder
and the bracket base to
make sure the device is
securely locked in place.
3. With the suction-cup
laying flat, position the
suction-cup on the
windshield.
4. Hold the base firmly on
the windshield and
press down the clamp
to mount the car holder
to the windshield. Make
sure the base is
securely locked in place.
5. Press and hold the
PUSH button and
connect the base to the
bracket.
6. Release the PUSH
button and make sure
the base is securely
locked in place.
Step2
Step1
9
Loading...
+ 20 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.