Genie S-100, Genie S-105, Genie S-120, Genie S-125, Genie S-100HD Quick Reference Manual

...

Download

Page 1

Quick Reference Guide

January 2017

Genie S-100 • Genie S-105 • Genie S-120

Genie S-125 • Genie S-100HD • Genie S-120HD

Rev A

Step 2

Step 3

Step 4

Step 5

Axle Extend

indicator light will stay on when the axles are

Steer Mode

Drive Enable

end tire and the drive function has

Engine idle select

indicates foot switch activated high idle

light on indicates low idle

Platform Overload

Drive Select Fault Indicator Light

that exist due to component failure or system

Operating Envelope Indicator Lights

extending the boom, raise the boom until the

lowering the boom, retract the boom until the

Quick Refer enc e Gui d e January 2017 Genie S

S-120HD

Rev A

-100 from SN 15D-1001

-105 from SN 15D-983

-120 from SN 15D-1012

-125 from SN 15D-984

-100HD from SN S100HD15D-212

-120HD from SN S120HD15D-208

This Quick Reference Guide is intended for operators who are properly trained to safely operate the machine.

Getting Started:

Step 1: Read the Operators Manual and Perform the pre-operation inspections and tests.

Turn to platform position.

Controls and Indicators:

Axle extend and retract indicator lights will flash while the axles are moving. Axle extend

fully extended. Axle retract indicator light will stay on when the axles are fully retracted.

Light on indicates that the boom has moved past a circlebeen interrupted. To drive, push the drive enable button and slowly move the drive/steer control handle off center. Use the color-coded direction arrows on the platform box and drive chassis to identify the direction the machine will travel.

Light flashing indicates the platform is overloaded. The engine will stop and no functions will operate. Remove weight from the platform until the light goes off and then restart the engine.

Machine on incline symbol

Pull out Red Emergency Stop buttons.

The indicator light next to the current steer mode will be on.

Rabbit and foot switch symbol light on

is selected. Rabbit symbol light on indicates high

idle is selected. Turtle symbol

is selected.

: Low range

Start Engine.

The operating envelope indicator lights will come on to notify the operator that a function has been interrupted and/or an action is required by the operator.

Uphill Position Downhill Position

Verify axles are extended.

Raise Boom light flashing

indicator light is off.

Retract Boom light flashing

indicator light is off.

Platform Not Level light flashing

alarm will be sounding when this light is flashing. The Platform Level toggle switch will only work in the direction that will level the platform. Level the platform until the indicator light is off.

achine Not Level Light Flashing

M alarm sounds when the platform is raised, the Not Level indicator light will come on and the drive function in one or both directions will not operate.

Follow the correct boom lowering sequence below based on the platform position. Do not rotate the boom while lowering.

operation for inclines.

Machine on level surface symbol

: High

range operation for maximum drive speed.

Light on indicates the machine has one or more faults. Faults are abnormal conditions

S-100 • S-105 • S-120 • S-125 • S-100HD • S-120HD

misuse. See the appropriate service manual.

-100 • S-105 • S- 120 • S-125 • S-100HD • S-120H D

-100 • Geni e S-10 5 • Geni e S-1 20 G eni e S-125 • Genie S-100HD • Geni e

: To continue

: The tilt

: If the tilt