Geniatech 16S95A2 User Manual

1

Enjoy TV
ENJOY TV Box
User’s Guide

2

1. Safety Information

Read and understand all instructions before using this product. If damage is caused by
failure to follow the instructions, the warranty does not apply.

1.1 Warning

To reduce the risk of electric shock, DO NOT remove the cover (or back).
DO NOT attempt to repair the product, this could lead to the risk of injury, damage to
the product .
To reduce the risk of fire or electric shock, keep this product away from exposed
direct sunlight, naked flames or heat, large amounts of moisture, dust, and sand.
FCC Note (for U.S.A)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on.
The user is encouraged to try to correct the interference by one or more of the
following measures.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

- This class B digital product meets all requirements of the Canadian Interference ­Causing Equipment Regulations.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
The distance between user and products should be no less than 20cm

1.2 Precautions

Important Safety Instructions
Read these operating instructions carefully before using the unit. Follow all the safety
instructions listed below.
Keep these operating instructions handy for future reference.

1.2.1 Read these instructions.

1.2.2 Keep these instructions.

1.2.3 Heed all warnings.

1.2.4 Follow all instructions.

1.2.5 DO NOT use this apparatus near water.

1.2.6 DO NOT clean with any chemical detergent. Clean only with a dry cloth.

3

1.2.7 DO NOT block any ventilation openings. Install in accordance with the
manufacturer’s instructions.

1.2.8 DO NOT install near any heat sources such as radiators, heat registers, stoves, or
other apparatus that produce heat.

1.2.9 Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where it exits the apparatus.

1.2.10 Only use attachments/accessories specified by the manufacturer.

1.2.11 Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used , use caution when
moving the cart/apparatus combination to avoid injury from tip-over.

1.2.12 Unplug this apparatus during lightning storms or when unused for long period
of time.

1.2.13 Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as when the power-supply cord or
plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.

1.3 Handling Cautions

1.3.1 DO NOT expose this apparatus to dripping or splashing. Do not put objects
filled with liquids, such as vases on the apparatus.

1.3.2 To turn this apparatus off completely, you must pull the power plug out of the
wall socket. Consequently, the power plug must be easily and readily accessible at all
times.

1.3.3 DO NOT plug multiple electric devices into the same wall socket. Overloading
a socket can cause it to overheat, resulting in a fire.

1.3.4 Before connecting other components to this player, be sure to turn them off.

1.3.5 If the product makes an abnormal noise or produces a burning smell or smoke,
turn off the power switch immediately and disconnect the power plug from the wall
outlet. Then, contact the nearest customer service center for technical assistance. Do
not use the product. Using the product as it is may cause a fire or an electric shock.

4

2. Introduction

2.1 Package Contents

Enjoy TV Box
User’s Guide
IR Remote Controller (IR RC)

Power Adapter, Input: AC100 ~ 240V, 50/60Hz, Output: 5V, 2A

2.2 Product Features

 HDMI input support
 ARM CORTEX A53 2.0GHz, RAM is 1G,built in 2G-32G flash memory
 Support Dual Band
 Powered by Android 5.1 OS
 Built in 802.11b/g/n WIFI module, wireless Internet access
 USB interface, support mobile HDD, wired/wireless mouse and keyboard
 RJ45 10/100M Ethernet interface
 Support 1080P video playback
 HDMI video output, connect to HDTV for HD video playback
 Support weather, calendar, and desktop clock gadgets
 Support Flash Player 10.2 for hardware decoding, Flash 11.1 for software

decoding ,play back online video

 Support music player, picture player and more family entertainment
 Support SD card, 4 USB ports and Google Chrome browser and virtual private

network access

 App Installer for application installation from USB/SD card

5

Display when Power Up

2.6.1 After power up, the TV will first show a green robot then change to “android”

logo during loading. When loading is finished, it will go to Home screen.

2.6.2 Home Screen display.

6

3. Settings

Using Navigation (4 directions), OK, EXIT, and Menu keys of Remote Controller to
select the options, the option selected will be highlighted and confirmed by pressing
OK key. Same operation for text input if needed.

Select icon then press OK key.

3.1 WiFi

3.1.1 It will automatically scan ambient WiFi networks when select “ON”.

3.1.2 Connect an available WiFi network. If connect a secured WiFi network,
corresponding password will be input firstly. Or fail to connect and need reset
password.

3.1.3 Once build up the connection with a certain WiFi network successfully,
ATV1220M will connect this WiFi network automatically when restart.
Note: If factory reset, the password of WiFi network have to be reset.

3.2 Ethernet

Connect Box and Router by RJ45 network cable.
Press “ ON” in Ethernet setting, it will connect to network automatically.