General Tools PE-14 User Manual
ELECTRICALLY INSULATED
14mm PROBE
USER’S MANUAL
NOTE: ETL SAFETY RATING ONLY APPLIES TO THE
DCS400 SERIES SYSTEMS.
PE14
Please read this manual carefully and thoroughly before using this product.
INTRODUCTION
Thank you for purchasing a PE14 Electrically Insulated Probe for
your Seeker
Wireless Recording Video Inspection System. Please read this
user’s manually thoroughly and carefully before using the
product.
The PE14 is a unique, electrically insulated, far-focus
camera-tipped probe that gives the DCS400 system it is
attached to an ETL safety rating of CAT III 1000V, CAT IV 600V.
™
400 Series (DCS400, DCS400-05 or DCS400-09)
Although the PE14 probe is also compatible with the
handle of Seeker 300, 200 and 100 (DCS300, DCS200
and DCS100) systems, attaching it to those systems
does NOT upgrade their safety ratings. General does
not advise and bears no responsibility for use of the
PE14 probe with any system other than the DCS400.
Working in concert with a DCS400, the PE14 makes it safe to
inspect two kinds of environments:
1. Any area or enclosure where you would expect to find
electrical wiring. Examples include junction and distribution
boxes, circuit breaker panels, electrical cabinets, equipment
chassis and enclosures, and motor control centers. Whether
the wiring is exposed or hidden, it represents a potential
hazard hazard to anyone operating a video camera scope
with a conventional probe with a metal exterior.
2. Any area or enclosure where you would not expect to find
electrical wiring, but exposed wiring nevertheless may be
present. Examples include attics, crawl spaces, rafters, ducts
and basements of houses—in short, any area that is too
inaccessible, confined or dark to be visible to the naked eye.
2
WARNING
Such areas may contain electrical hazards created by age
(worn insulation, e.g.) or structural modifications.
The PE14 makes it possible to inspect electrically hazardous
areas (as well as safe areas) using the capabilities and
features of a Seeker 400 Series system. The probe has many
applications in the automotive/boat/aircraft repair, plumbing,
construction, restoration and HVAC/R industries.
KEY FEATURES
• Attachment to DCS400 Series video camera scope
gives entire system an ETL safety rating of CAT III
1000V, CAT IV 600V
• Flexible-obedient design lets user bend probe into
different shapes and hold them to facilitate inspection
of different areas
• 14mm diameter enables use in close quarters
• Wide depth of field of 1 in. (25mm) to infinity for clarity
at all distances
• Adjustable LED lights inside probe tip illuminate dark
spaces
• Water, dust, oil and scratch-resistant to IP67 standard
3
Loading...