General Electric PT925DNBB User Manual
PT925DN
CUTOUT
HEIGHT
27 1/4" MIN.
27 5/16" MAX.
CUTOUT
WIDTH
28 1/2" MIN.
28 5/8" MAX.
5"
22" TO
BOTTOM OF
JUNCTION BOX
JUNCTION
B
LOCATIO
N
RECOMMENDED
CUTOUT
LOCATION
32 1/2"
FROM THE
FLOOR
CABINET
WIDTH
30"
ALLOW 11/16" FOR
OVERLAP OF THE
OVEN OVER SIDE
EDGES OF CUTOUT
THE OPENING
BETWEEN INSIDE
WALLS MUST
BE AT LEAST
28 1/2"WIDE
ALLOW 1" FOR
OVERLAP
ON OVEN TOP
AND BOTTOM
OF CUTOUT
21"
ALLOW A MINIMUM
21" FOR CLEARANCE
ADJACENT CORNERS,
AWERS, WALLS ETC.
N
THE DOOR IS OPENED.
Allow 11/16”
(1.75 cm) for
overlap of oven
over side edges
of cutout
Cutout
Width
28 1/2”
(72.4 cm)
Min.
28 5/8”
(72.7 cm)
Max.
15”
(38.1 cm)
Cabinet
Width
30”
(76.2 cm)
Allow a minimum
of 15” (38.1 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
Allow 1” (2.5 cm)
minimum for
overlap of oven
top and 1 1/4”
(3.2 cm) overlap
of oven bottom
of cutout
Recommended
cutout
location from
floor 26 1/2”
(67.3 cm) max
Opening
Between
Inside Walls
Must Be
At Least
28 1/2”
(72.4 cm)
Wide
Junction Box
Location
(junction box
may be
located in
adjacent
cabinet)
9 1/2”
(12.7 cm)
Max.
Cutout
Height
27 1/4”
(69.2 cm) Min.
27 5/16”
(69.4 cm) Max.
22” (55.9 cm)
Min. to
Bottom of
Junction Box
C
L
2 x 4 or
equivalent
runners
Suitable
bracing
to support
runners
21-5/8"
over centerline
of cabinet
(must support 275 lbs.)
GE Profile™ 30" Built-In Single/Double Convection Wall Oven
Dimensions and Installation Information (in inches)
KW Rating
240V
208V
Breaker Size
240V
208V
Most 30” Wall Cabinets can be used with this unit.
Note: These ovens are not approved for
stackable installations. Cabinets installed
adjacent to wall ovens must have an adhesion
spec of at least a 194°F temperature rating.
Door handle protrudes 3" from door face. Cabinets
and drawers on adjacent 45° and 90° walls should
be placed to avoid interference with the handle.
Electric wall ovens are not approved for
installation with a plug and receptacle. They
must be hard wired in accordance with
installation instructions.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Side-by-side installations require at least 2"
between cutouts.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
3.9
2.9
20 Amps
20 Amps
Listed by
Underwriters
Laboratories
Specification Revised 4/09
220244
PT925DN
NOTE: This oven is only
approved to be installed under
the speci c models as labeled
on this unit.
Installation Instructions
Cutout for 30
(76.2 cm)
Single Double
Oven Under Counter
MUST SUPPORT 200 LBS. (91 Kg)
240V / 208V
Junction Box
Location (junction
box may be in
adjacent cabinet)
Allow 1” (2.5 cm)
overlap top
of oven,
11/16” (1.8 cm)
overlap side edges
of cutout and
1 1/4” (3.2 cm)
overlap bottom
of oven.
Top and/or side llers
may be necessary
if unit is positioned
between existing
cabinets. Be sure
they are attached
securely, since they
will anchor the oven
in the cabinet.
Electric cooktops may be installed over this oven. See cooktop
installation instructions for cutout size. See label on top of oven
for approved cooktop models.
28 1/2” (72.4 cm) Min.
28 5/8” (72.7 cm) Max.
27 1/4” (69.2 cm) Min.
27 5/16” (69.4 cm) Max.
A
36” (91.4 cm)
Typical
Countertop
Height
22” (55.9 cm) Min.
Above Support
Platform
9 1/2”
(24.1 cm)
Max.
25” (63.5 cm)
24” (61 cm)
Must
match
toekick
height
4” (10.2 cm)
Typical
Toekick
3/4” (1.9 cm)
Support Platform
Required
Cutout Observe all
dimensions
and
requirements.
Center Line
30.5”
(77.5 cm)
Center Line
Cutout Observe all
dimensions
and
requirements.
2” (5.1 cm)
Min.
GE Profile™ 30" Built-In Single/Double Convection Wall Oven
Optional Undercounter Dimensions and Installation Information
Note: Specific 30" and 36" radiant cooktops
with knob controls are approved for use over
the GE Profile single/double PT925: JP346,
JP356, PP912, PP932, PP942, JP655, PP963,
PP972 and ZEU36K. Refer to cooktop and wall
oven installation information packed with
products for current dimensional data.
Note: Gas cooktops are not approved for use
over the GE Profile single/double PT925. The
gas cooktops are too deep to fit above the new
wall oven.
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating.
Note: 30" and 36" Induction cooktops with
knob-free electronic controls are approved for
use over the GE Profile single/double PT925:
PHP900, PHP960, ZHU30 and ZHU36.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 4/09
220244
Loading...