Genelec 1038-437B Instruction Manual

WALL MOUNT 1038-437B for GENELEC 1038CF/1238CF

adjustable in direction and angle

instruction manual

1. mounting preparation

1.a Loosen split pin, washer, nut, bolt

1.b Pull out the threaded rod

1.c Detach the frame

3. wall mount options

3.a concrete wall - e.g.: steel-anchor-bolt M 6 x 65 mm

3.a - drill and blow out hole, place anchor, wall bracket and washer,

3.a - tighten hexnut

2. wall bracket fastening

2.a Adjust wall plate vertically

2.b Anchor holes drilling (4x)

2.b diameter 10 mm

3.b perforated bricks - e.g.: unsiversal frame fixing set 8 x 80 mm

3.b - drill, countersink and blow out hole, place anchor and bracket, fix

3.b - hexagon head wood screw

3.c injection-molded-anchor

without sieve bushing for concrete wall - with sieve bushing for perforated
bricks / optional with threaded bolt M6 or threaded bushing M6

NOTE: fixing without pressure, enables repeated mounting, capable for diverse

NOTE: wall materials (please notice instructions of anchor manufacturers).

4. installation after wall bracket fastening

4.a Attach the frame

4.b Move in the threaded rod

4.c Place the joint bar above the thread and ...

4.d ...screw the castle nut to the threaded rod

4.e Secure the bolt assembly by mounting the split pin

4.f Bolt together (4x) vertical rod and speaker arm

4.f (tighten w/28Nm)

WALL MOUNT 1038-437B for GENELEC 1038CF/1238CF

adjustable in direction and angle

instruction manual

5. dimensions (mm)

Weight: 6.0 kg

6. settings

6.a tilt angle continously adjustable down to 28°

6.a by fixing the upper bolted assembly

6.b Pivoting attachment arround vertical axis

6.c Expanding mandrel for firm speaker fit

7. mandrel adjustment

SETTING UP of 1038CF/1238CF

7.a Set up the speaker upon

7.a the plugged-in mandrel

7.b Remove cap from the

7.b nut below the mandrel

7.c Screw-on the hex-nut M8

7.c (13mm) until the expanding

7.c brackets fix the speaker

8. safety instructions

- only for GENELEC 1038CF/1238CF

- choose a position and mounting method compliant with local building codes and regulations

- for use only by trained installers -Use four anchors per wall bracket

- for use only at proper walls with adequate anchors (see 3.)

- not suitable are fragile walls. Beware of power supply lines and water conduits. Ask an expert

- inspect bolted assemblies periodly

- for indoor use only

GENELEC Oy

Olvitie 5, Fin-74100 Iisalmi, www.genelec.com

24477-000-55 Rev.01 03-80-377-00 3/13

REMOVAL of 1038CF/1238CF

7.d Remove cap and loosen

7.d the hex-nut M8 (13 mm)

7.e Hit the thread (dosed force)

7.e with a mallet to release

7.e the tight brackets 7.f Remove the speaker