Geemarc Petite Trac User Manual

PETITE TRACPETITE TRAC
PETITE TRAC
PETITE TRACPETITE TRAC
User guide
Telephone radio alarm clock
SETTING UP
FIT A 9 VOLT PP3 BATTERY
Why? Because if you have a power cut or disconnect your Petite Trac for any reason you won't have to re-set the clock.
- Remove the battery coverunderneaththetelephone.
- Replace the battery cover.
NOTE: Battery back-up is not designed to support the clock operation for lengthy periods in the absence of mains supply. It is recommended that the battery be changed every 6 months or earlier if necessary.
IMPORTANT:Dispose of batteries carefully. Never burn them or let children play with them.
CONNECTING TELEPHONE
- Connect the handset cord.
- Connect the PTT line cord to the telephone.
- Connect the PTT plug to the wall socket (classified TNV-3according to EN60950 standard).
- Connect the AC adaptor plug into the socket at the rear of the base unit.
- Connect theAC adaptor to the wall socket (classified “hazardous voltage” according to EN60950 standard).
SETTING UP
CLOCK TIME SETTING
The correct time should be set as follows:
- Press and hold down Time button.
- Whilst holding down the Time button, press Hour and then Minute buttons as necessary to display the correct time. Note: that the clock is a 12 hour clock; in the case of PM, an indicator will show to the top left of the clock display.
RINGER SETTING
A switch (Ringer) located on the rear of the base unit allows the ringer to be switched On or Off. If you do not wish the telephone to ring, set the switch to the Off position. The ringer lamp will still flash on receipt of a call. Outgoing calls can still be made when the switch is set to the Off position.
DIMMER SETTING
A switch (Dimmer) located on the left side of the base unit allows to adjust (Hi or Lo) the brightness of the display.
Loading...
+ 7 hidden pages