Geemarc Dallas 10 User Manual

DD

ALLAS 10ALLAS 10

D

ALLAS 10

DD

ALLAS 10ALLAS 10

User guide

T.B.A.

If you are using this telephone with a hearing aid, set your

hearing aid to the «T» setting

Telephone

SETTING UP

T .B.A.

Drawing description

1 - CONNECTING TELEPHONE

1 - Connect the handset cord.
2 - Connect the line cord to the socket located
at rear of telephone then connect the PTT plug*.

(*) Classified TNV-3 according to EN60950 standard.

SETTING UP

2 - RINGER SETTINGS

A switch located on right side allows the ringer to
be switched On (

3 - W ALL MOUNTING

T o wall-mount your telephone,slide out the clip turn
around and slide back into the wall mounting posi­tion (located in the base unit, just below the ear
piece).This will ensure that the handset stays firmly
in position. Make 2 holes in the wall 85mm apart,
insert the wall plugs and the wall mounting screws.
The screws should protrude from wall by 6-7 mm.
Place the phone onto the screw-heads and slide
down to secure.

4 - TONE/PULSE SWITCH (T/P)

) or Off ( ).

The Tone/Pulse switch is factory pre-set to Tone
position (T).In the UK,all telephone exchanges now
use Tone dialing. If your phone does not dial out it
is probably being used from an older private switch
board (PBX). In this case, the Tone/Pulse switch
must be moved to Pulse (P).