GE Digital IC695ACC302 Specifications
PACSystems*
IC695ACC302
GFK-2592B Auxiliary Smart Battery Module
April 2016
The IC695ACC302 Auxiliary Smart Battery module is an enhanced version of the IC693ACC302 Auxiliary
Battery module. The IC695ACC302 Auxiliary Smart Battery module provides extended volatile memory
backup time compared to that of the standard coin cell batteries for PACSystems CPUs and includes reliable
low battery detection for compatible CPUs.
For details on the operation of specific CPU models, refer to the PACSystems CPU Reference Manual
(GFK-2222).
For additional details on battery installation, operation, safe handling and disposal, and agency certifications,
refer to the PACSystems Controllers Battery and Energy Pack Manual (GFK-2741).
Date Code
The date code is located on the product label at the right bottom edge. The date code consists of four digits,
such as 1011. The first two digits represent the year of manufacture in the 21
year 2010. The last two digits represent the fiscal week of manufacture for the indicated year (for example 11
stands for fiscal week 11).
st
century, such as 10 for the
Installation Information
While installing the battery to the CPU, first connect the four-pin Male JAE connector on the enabling adapter
cable to the female four-pin JAE connector on the battery module as displayed in the following figure.
(Installing the four-pin connector enables the battery.)
Note: The battery will begin to drain immediately if attached to the CPU in Power OFF condition. To
maximize battery life, it is recommended that you install the fresh battery after power has been turned
ON to the attached CPU.
Note: Once the enabling adapter cable is connected, the battery starts to drain, even if it is not attached to
the CPU. It is recommended to disconnect the enabling adapter cable from the battery module when
the battery is not in use. Even though the discharge current would be negligible with just the enabling
adapter cable connected, this can affect battery life if left in this condition for long durations.
© 2016 General Electric Company. All Rights Reserved.
*
Indicates a trademark of General Electric Company and/or its subsidiaries. All other trademarks are the property of
their respective owners.
2 IC695ACC302 Auxiliary Smart Battery Module
of RX7i CPUs
IC695ACC302-AA
1.0
March 2011
Initial release
GFK-2592B
The battery used in this device may present a risk of fire, explosion, or chemical
burn if mistreated. Do not short-circuit, crush, disasse mble, or dispose of with fire.
Use of a battery not specified by the manufacturer may present a risk of fire or
Warning
explosion.
EXPLOSION HAZARD – Do not install or replace the battery module unless the
area is known to be non-hazardous.
Warning
Safe Handling and Disposal
For safe handling and disposal of dead battery modules, reference the manufacturer’s Material Safety Data
Sheet (MSDS) and the Battery Disposal Document included with this product.
Release History
Catalog Numbers Version Date Comments
Resolves issue with indication of correct low
IC695ACC302-AB 1.1 August 2012
battery period when used with higher versions
Problems Resolved in this Version
When the Smart Auxiliary battery, IC695ACC302-AA is used with the PACSystems
CPU320/CRU320/CPE030/40 and CRE030/040 CPUs, it may not indicate the correct battery low period of
15 days. This problem is resolved in the –AB version.
For details on CPU compatibility and version requirements, refer to the PACSystems Controllers Battery and
Energy Pack Manual (GFK-2741).
Related Documents
PACSystems CPU Reference Manual (GFK-2222)
PACSystems RX7i Installation Manual (GFK-2223)
PACSystems RX3i System Manual (GFK-2314)
PACSystems Controllers Battery and Energy Pack Manual (GFK-2741)
Loading...