22-1/4"
29-3/4"
21-1/2"
Recessed
Depth
19"
29-3/4"
21-1/2"
Recessed
Depth
ZSC2200N/ZSC2201N/ZSC2202N
GE Monogram® Built-In Advantium® Oven
Dimensions and Installation Information (in inches)
Electrical Requirements
KW Rating
208/240V 6.3
Breaker Size
208/240V 30 Amps
Single Speedcook Installation
Product rating is 120/208 or 120/240 volt, 60 Hz, 30 amps. This product
must be connected to a supply circuit of the proper voltage and
frequency and protected by a time delay fuse or circuit breaker. The
power supply should be brought to a separate 30 ampere branch circuit.
Wire size must conform to the requirements of the National Electric Code
or the prevailing local code.
Combined Speedcook and Wall Oven Installation:
When installed in combination with a Monogram single wall oven, use
separate electrical junction boxes,
• Refer to single oven installation instructions for electrical requirements
of that product.
• These connections must be made by a qualified electrician. All
electrical connections must meet National Electrical code or prevailing
local codes.
Installation Requirements
• These ovens must be installed directly into
a wall or wall oven cabinetry, 30" minimum
width.
• This oven can be installed over any
Monogram single electric built-in oven or a
single Monogram warming drawer.
• This oven must be installed at least 36-3/4"
above the floor.
IMPORTANT: This oven is not approved for use
above another built-in Advantium oven, side by
side or under the countertop installations.
with optional storage
drawer ZX2201NSS
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Specification Created 6/08
Listed by
Underwriters
Laboratories
130310
ZSC2200N/ZSC2201N/ZSC2202N
36-3/4"
Min.
30"
23-1/2"
Construct Base
Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
17-1/2"
25-1/4"
36-3/4" Min.
30"
23-1/2"
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Warming
Drawer
Requirement
25-1/4"
17-1/2"
30"
23-1/2"
36-3/4" Min.
45-1/4"
Recommended
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
17-1/2"
25-1/4"
30"
23-1/2"
17-1/2"
45-1/4"
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Oven
Requirement
2" Min.
Per warming drawer requirement
25-1/4"
GE Monogram® Built-In Advantium® Oven
Dimensions and Installation Information (in inches)
Important: These installation cutouts do not include the accessory drawer.
Single Advantium 240V installation
• Maintain 36-3/4" minimum height from the floor
to the cutout in any single or combined installation.
• Allow 2-1/8" case trim overlap on the sides and 7/8"
overlap on the bottom. Allow 3/4" overlap at the top
of the oven.
Installation over a Monogram
Warming Drawer
Installation over a Monogram Oven
Additional clearances between the cutouts may be
required. See oven installation instructions for details.
Installation over a Monogram Oven and
Warming Drawer
Additional clearances between the cutouts may be
required. Check to be sure the oven supports above the
warming drawer do not obstruct the required interior
depth and height. See warming drawer installation
instructions for details.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Additional clearances between the cutouts may be
required. See warming drawer and oven installation
instructions for details.
Listed by
Underwriters
Laboratories
Specification Created 6/08
130310
ZSC2201NSS with ZX2201NSS
GE Monogram® Built-In Advantium® Oven with Accessory Drawer
Dimensions and Installation Information (in inches)
ZSC2201NSS and ZX2201NSS Accessory - GE Monogram Built-in Advantium Oven and Accessory Drawer
Important: These installation cutouts include the ZX2201NSS accessory drawer.
ZSC2201NSS Advantium Installation with
Accessory Drawer
30"
36-3/4"
Min.
• Maintain 36-3/4" minimum height from the floor to the
cutout in any single or combined installation.
• Allow 2-1/8" case trim overlap on the sides and 7/8" overlap
on the bottom. Allow 3/4" overlap at the top of the oven.
21"
23-1/2"
25-1/4"
Min.
Construct
Base
Min. 3/8"
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
21-1/2"
Recessed
Depth
22-1/4"
29-3/4"
ZSC2201NSS Advantium and Accessory
Drawer Installed over a Monogram
Warming Drawer
23-1/2"
30"
25-1/4"
21"
36-3/4" Min.
Additional clearances between the cutouts may be
required. Check to be sure the oven supports above the
warming drawer do not obstruct the required interior
depth and height. See warming drawer installation
instructions for details.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min
Per Warming
Drawer
Requirement
ZSC2201NSS Advantium and Accessory Drawer
Installed over a Monogram Oven
36-3/4”
Min.
45-1/4”
Recommended
Additional clearances between the cutouts may be required.
See oven installation instructions for details.
ZSC2201NSS Advantium and Accessory Drawer
Installed over a Monogram Oven and
Warming Drawer
30"
45-1/4"
23-1/2"
25-1/4"
21"
Per warming drawer requirement
Additional clearances between the cutouts may
be required. See warming drawer and oven installation
instructions for details.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Oven
Requirement
2" Min.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Specification Created 6/08
Listed by
Underwriters
Laboratories
130310
ZSC2200N/ZSC2201N/ZSC2202N
LOCK/UNLOCK
HOLD 5 SECONDS
OVEN
MICROWAVE
LOCK/UNLOCK
HOLD 5 SECONDS
OVEN
MICROWAVE
GE Monogram® Built-In Advantium® Oven
Dimensions and Installation Information (in inches)
Features and Benefits
• Four Ovens in One - Speedcook, convection,
microwave and warming capabilities
• Award-Winning Speedcook Technology - Delivers
oven-quality results up to eight times faster
than conventional cooking methods with no
preheating
• Integrated Appearance - Makes a singular
architectural impression with signature
Monogram tubular handles (models
ZSC2200NBB and ZSC2201NSS)
• Professional, Stainless Steel Appearance
- Designed with chamfered edges, a robust
tubular handle and die-cast control knob
(model ZSC2202NSS)
Integrated
• True European Convection Mode - Bakes, roasts
and browns foods to perfection
• Microwave Mode - Provides a fully functioning
sensor microwave that allows fast, precise
reheating and defrosting
• Warming Mode - Keeps prepared dishes at
ready-to-serve temperatures
• Proofing Mode - Allows dough to rise quickly
and efficiently
• Model ZSC2000NBB – Black
• Model ZSC2001NSS – Integrated Stainless steel
• Model ZSC2002NSS – Professional Stainless steel
• Optional Accessory Storage Drawer - ZX2201NSS
(for use with ZSC2201NSS only)
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Professional
Specification Created 6/08
130310
Loading...