Page 1
ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module
34-1/2"-35"
24" Min.
23-3/4"
34-1/2"
23-3/4" Stainless Steel
Models
24-7/8" Framed Models
1-1/2"
Locate Outlet
9"
Max.
10-1/2"
Depth Including
Handle:
26" Stainless Steel
Models Only
23-3/4" Min.
Note: If installing between frameless
cabinets, a 1/2" wide filler strip or side panel
may be required. The filler strip will act as a
spacer between the door case and adjacent cabinet
and will prevent interference with cabinet door swing.
The width of the opening must include filler panels.
16" Minimum
110˚
Wall
24"
Cabinet
14" Minimum
110˚
Wall
24"
Cabinet
(Custom panel required)
ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module
(Stainless steel)
Dimensions and Specifications (in inches)
Installation Space
The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and access
to the pull-out racks when installed as a built-in.
• The Fresh-Food Refrigerator can be free-standing.
• The stainless steel model ZIFS240PSS can be installed flush with
standard cabinetry. ZIFI240PII with custom panel will project
forward 1-3/4" of adjacent 24" deep base cabinets.
• Note: Door swing is not reversible.
Product Clearances
Models with a Custom
Door Panel
All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow 4" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 4-1/2" min. clearance to wall on the hinge side for models
with a custom panel and custom handle.
For a full 110° door swing:
• Allow 14" min. clearance to wall on the hinge side for Stainless
Steel models.
• Allow 16" min. clearance to wall on the hinge side for models with
a custom panel and custom handle.
Stainless Steel
Models
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
Specification Revised 5/08
120032
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
Page 2
ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module
34-1/2" - 35"
24" Min.
47-1/2" Min.
1-1/2"
Locate Outlets
9"
Max.
10-1/2"
1-1/2"
9"
Max.
10-1/2"
24"
Overlay
Panel
1/4"
Backer
Panel
Door
.10 Inch
Spacer
Spacer Panel
Backer Panel
Overlay Panel
A
B
(Custom panel required) )
ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module
(Stainless steel)
Dimensions and Specifications (in inches)
For a complete food storage center, install two Monogram refrigeration
modules side-by-side.
Note: Reversible door swing on wine chillers/reserves and beverage
centers only.
Important Note: Products must operate from separate, properly
grounded receptacles.
3/4” Overlay Panel Dimensions
Model ZIFI240PII requires customer-provided
overlay door panel.
• The overlay panel must be secured to a 1/4"
thick backer panel which slides into the trim.
A .10" thick spacer panel must be placed
between the custom and backer panel.
• A custom handle of your choice, supplied by
your cabinet maker, must be installed on the
overlay panel.
Use a 3/4" router bit to cut a notch into the back side
of the assembled panel to allow for hinge clearance.
3/4" Overlay Panel Dimensions (in inches)
A (Width) B (Height)
1/4" Backer 23-3/16" 29-9/16"
0.10" Spacer 22-1/2" 29-1/16"
3/4" Overlay 23-5/8" 30"
NOTE: Max. assembled drawer panel weight
is 25 lbs.
Note: Additional cutout width may be required for models with
custom panels.
Grounding the Fresh-Food Refrigerator
IMPORTANT – (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with a 3-prong
(grounding) plug which mates with a standard 3-prong (grounding) wall
receptacle to minimize the possibility of electric shock hazard from this
appliance.
Have the wall outlet and circuit checked by a qualified electrician to
make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your
personal responsibility and obligation to have it replaced with a
properly grounded 3-prong wall out.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE
REFRIGERATOR TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH THIS APPLIANCE.
Specification Revised 5/08
120032
Assemble overlay panels with glue
and screws.
• Center spacer panel on the backer
panel, left to right and top to bottom. Secure the panels with glue.
• Center the spacer/backer panel
on the overlay panel. Secure with
glue and screws. Countersink
screws into the backer panel.
Listed by
Underwriters
Laboratories
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
Page 3
ZIFI240PII – GE Monogram Fresh-Food Refrigerator Module
(Custom panel required)
ZIFS240PSS – GE Monogram Fresh-Food Refrigerator Module
(Stainless steel)
Features and Benefits
• Electronic adjustable temperature control – Offers a range
of temperatures for precise chilling
• LED temperature display – Allows you to monitor the
temperature at a glance
• Clear LEXAN
easy access to contents
• Removable spillproof glass shelves – Helps contain spills
for ease of cleaning
• QuickSpace
room for tall items
• Custom panel and handle required – Customer must install
a custom door panel and handle to complement their
décor (ZIFI240PII only)
• Model ZIFS240PSS – Stainless steel
• Model ZIFS240PLSS – Stainless steel, left hinge
• Model ZIFI240PII – Custom panel and handle required
• Model ZIFI240PLII – Custom panel and handle required,
left hinge
®
crisper on full-extension slides – Provides
™
Shelf – Quickly slides out of the way to make
Specification Revised 5/08
120032
Loading...