GE SnapDrive Installation Guide
GE
g
READ THOROUGHLY BEFORE INSTALLING
Lighting Solutions
WARNING
Risk of electric shock
• Turn power off before servicing
– see instructions
GENERAL
This is a high quality replacement SnapDrive™, that is
designed to give many years of reliable service when used
properly. Proper line voltage, frequency, lamp, mounting,
and environment are necessary. Each SnapDrive is tested
for proper operation before shipment. Care should be
taken when mounting and connecting the SnapDrive, and
should be performed only by qualified personnel.
GEH-5804A
INSTRUCTIONS
SnapDrive™Electrical System
be removed. Then, release latch at one end of the unit, in
most cases no screws are to be loosened for this process.
Unit can now be removed.
UNPACKING
This SnapDrive has been properly packed so that no
parts should have been damaged during transit. Inspect to
confirm.
INSTALLATION
CAUTION
Unit will fall if not installed properly
• Follow installation instructions
CAUTION
Risk of burn
• Allow lamp/fixture to cool before
handling
The faulty SnapDrive should be removed first. This is
accomplished by disconnecting all plugs that have wires
going to other parts of the fixtures. First disconnect the
power harness and then if applicable, disconnect switch
quartz and bi-level plugs. Jumper plugs are not required to
Note: If unit is direct mounted with screws (3) the
above procedure is correct except for latching.
Instead, loosen then tighten the 3 screws holding
the SnapDrive in the luminaire. Reinstallation is
accomplished by orienting new SnapDrive in same
direction and by retightening screws.
Check to ensure new SnapDrive is the correct type.
To install the new SnapDrive, hook keyholes on mounting tabs and push other end into spring latch. A positive
‘click’ sound indicates proper engagement. Place jumper
plugs in proper positions – voltage, wattage and switch
quartz as required.
Note: Failure to place jumpers in proper position
can destroy new Snap Drive Electrical System and
other accessories. Proper voltage positions are
indicated on the circuit board and in the Wiring
Diagram attached to each Snap Drive.
Reconnect main power plug. Close fixture.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred
to GE Lighting Solutions.g
SnapDrive™ – Large
Keyholes
for ‘hooks’
or screws
SnapDrive™ – Medium
Power Plug
Switch Quartz
Plug
Bi-Level / Wattage
Selector Plug
Tab
or
Screw
Voltage Plug
Voltage Plug Power Plug
Tab
or
Screw
Bi-Level / Wattage
Selector Plug
Switch Quartz Plug
Keyholes
for ‘hooks’
or screws
SnapDrive™ – Small
Tab
or
Screw
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company.
© 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Switch Quartz PlugPower Plug
Voltage Plug
Keyholes
for ‘hooks’
or screws
16943533----888
35-201578-5C (11/01)
Loading...