GE PP7030SJSS Specification Sheet

PP7030SJ

PP9030SJ, PP7030SJ, JP5030SJ

ADA

COMPLIANT

GE Profile™ Series 30" Built-In Knob-Control Electric Cooktop

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)

IMPORTANT: Requires a 5" free area between

the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires a 15"
minimum from cooktop to adjacent overhead
cabinets. Units are furnished with a 48" flexible
armored cable.

NOTE: 30" Ribbon cooktops are approved for use
over select GE 27" and GE 30" Single Wall Ovens
and Warming Drawers. Refer to cooktop and wall
oven/warming drawer installation instructions
packed with product for current dimensional
data. If installed with a GE Telescopic Downdraft
System, consult both the cooktop and downdraft
installation instructions packed with product
before installing. Cooktop gas/electric supply
may need to be re-routed to install downdraft.
The countertop cutout requires 23-1/2" minimum
flat countertop surface and 25" minimum total
countertop depth. In addition, other clearances to
front edge of the countertop must be considered.

Before installing, consult installation
instructions packed with product for current
dimensional data.

CUTOUT FILLER TRIM KIT: A filler trim kit
is available for use if your countertop cutout
is larger than the dimension shown, up to
29-13/16" x 20-7/16". Order JXTR32B for black or
JXTR32W for white, to reduce the cutout opening
for installation of this cooktop. These kits may be
ordered from your GE Appliances Dealer.

APPROXIMATE COOKING DIMENSIONS

28"

21"

19-5/8" to

19-3/4"

3-1/4" at front of unit and
5-9/16" at conduit location

19-1/4"

1-3/4" MIN.

to rear wall

2-1/2" MIN.

Required

To insure accuracy, it is best to make a
template when cutting the opening in the counter

VOLTAGE (60HZ AC) 240V
CONNECTED LOAD (MAX.) 9.5kW
CURRENT DRAW (MAX.) 39.6 Amps 34.3 Amps
RECOMMENDED CIRCUIT BREAKER†40 Amps 40 Amps

†

NOTE: Check local codes for required breaker size.

29-7/8"

Cooktop

28-1/2" to

28-5/8"

13" MAX. depth of unprotected

overhead cabinets (when no
hood or microwave is installed)

30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)

Electrical junction box 16" MIN.

below countertop

2" MIN. clearance

to side wall from cut-out

on left sides of unit and

1-1/2" clearance on

right side of unit

208V

7.1 kW

15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop

Listed by
Underwriters
Laboratories

For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.

Speci fication Revised 6/16

PP7030SJ

GE Profile™ Series 30" Built-In Knob-Control Electric Cooktop

FEATURES AND BENEFITS
Five radiant cooking elements - Cook foods quickly and evenly
on this sleek, glass surface

6"/9" Power Boil element - Use different pan sizes on this single, 3,100-watt
flexible element that produces rapid powerful heat

5"/8" dual element - Use different pan sizes on this single,
2,200-watt flexible element

SyncBurners - Control two 7" elements simultaneously to evenly heat large
cookware or griddles*

Keep Warm setting - Keep food warm with GE Appliances' lowest heat setting
or boil water in minutes with this fully functional 6" element

Melt setting - Gently melt delicate foods without burning or scorching

Control lock capability - Protects against unintended activation

Red LED backlit knobs with black glass surface and stainles steel trim

- Achieve a modern look with the convenience of knob controls that
complements the entire kitchen and other stainless steel appliances

Hot surface indicator lights - Know when elements are too hot
to touch with a quick glance

Cooktop “On” indicator light - A light lets you know when an element is active

Model PP7030SJSS - Stainless steel

* OPTIONAL STAINLESS STEEL CLAD

ALUMINUM GRIDDLE

Achieve even results with this lightweight griddle,
tailored to fit GE SyncBurners. Order part number
JXGRIDL1 from your GE Dealer.

GUARANTEED FIT
Replacing a similar cooktop from GE or another
brand? GE cooktops are guaranteed for an exact fit
to make replacement easy

Visit geappliances.com for more info

Speci fication Revised 6/16