GE PM 16, PM 17 Instructions Manual

GE

g

READ THOROUGHLY BEFORE INSTALLING

Lighting Solutions

WARNING

Risk of electric shock

• Turn power off before servicing
– see instructions

GENERAL

This luminaire is designed for outdoor lighting
applications and should not be used in areas of limited
ventilation or in high ambient temperature enclosures. Best
results will be obtained if the luminaire is installed and
maintained according to the following recommendations.

GEH-3912C

INSTRUCTIONS

PM 17 & PM 16

UNPACKING

This luminaire has been properly packed to protect it
during transit. Unpack, inspect, and notify the distributor
or shipping agent of any damage found.

MOUNTING

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

This luminaire is provided with means for mounting on
2 in. (2.375 O.D.) to 3 in. (3.500 O.D.) pole tops.

INSTALLATION

Refer to figure A.

Make all electrical connections in accordance with

the National Electrical Code and any applicable

local code requirements.

Figure B

1. Certain models have a shield to protect the user from
exposure to electrical components while relamping.
This shield must be removed to install power supply
leads to the terminal board. This shield MUST be
replaced after making the supply connections. (See
Figure B)

2. Feed the power supply leads through the slip-fitter wire
access hole as the fixture is installed on the pole. Level
and secure the fixture to the pole by tightening the
three set screws in the slipfitter.

Figure A

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred
to GE Lighting Solutions.

3. Connect power supply leads to the terminal board
making sure that the ground lead is mated with the
terminal receiving the green grounding wire.