GE PDT855SIJII Specification
PDT855SIJII
GE Profile™ Series Stainless Steel Interior Dishwasher with Hidden Controls
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
††
ELECTRICAL RATING
Voltage AC................................................................120
Hertz..........................................................................60
Total connected load amperage................................9.0
Calrod® heater watts max.......................................1060
For use on adequately wired 120-volt, 15-amp circuit
having 2-wire service with a separate ground wire.
This appliance must be grounded for safe operation.
Part # WD35X20417
INSTALL AT I O N INFORM ATI O N : Before installing,
consult installation instructions packed with product
for current dimensional data.
This Wall Area
must be Free
of Pipes or
33-1/2" to 34-3/4"
Underside of
Countertop
to Floor
Figure A
wires
Plumbing and Electric Service
Must Enter Inside This Area
24"
Min.
4"
24"
Min.
6"
Cabinets
Square
and
Plumb
Typical
33-3/8" MIN.
adj to
34-5/8" MAX.
24"
23-3/4"
29-7/8"
27-1/2"
4" (toekick)
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Listed by
Underwriters
Laboratories
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Speci fication Rev ised 8/18
PDT855SIJII
Top of Panel Top of Panel
Bottom of Panel Bottom of Panel
GE Profile™ Series Stainless Steel Interior Dishwasher with Hidden Controls
CUSTOM DISHWASHER DOOR PANEL TEMPLATE
CALL 1-800-626-2000
For a full-size panel template with
complete panel installation instructions.
Part # WD35X20417
CUSTOM PANEL
IMPORTANT: TO ENSURE OPTIMUM
DOOR BALANCE PERFORMANCE, THE
CUSTOM PANEL MUST NOT WEIGH
MORE THAN 20 LBS.
A custom handle must be installed onto the
custom panel. Install the custom handle
4-1/2" max. from the top of the panel.
23 3/4" (60.3)
29 13/16"
(75.7) min
30 1/4"
(76.8) max
Panel
Side
of
Drill 3/32"
Pilot Hole
3/32" Deep
Trim Around Dotted Line
Trim Around Dotted Line
For Reference Only
Not to Scale
Mark Center
Screw Holes
Screw
Spacer
Drill 3/32"
Pilot Hole
3/32" Deep
Side
of
Panel
Gray
Light Duty
Blue
Medium Duty
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Drill 3/32"
Pilot Hole
3/32" Deep
Trim Around Dotted Line
Trim Around Dotted Line
Drill 3/32"
Pilot Hole
3/32" Deep
Speci fication Rev ised 8/18
Loading...